Loading ...
Loading ...
Loading ...
7.3 ASSEMBLE THE GUIDE BAR AND
THE CHAIN
1. Loosen the chain cover by turning the bar nut (22)
counterclockwise.
2. Remove the chain cover (10).
21
22
3. Put the chain drive links (17) into the bar groove (15).
4. Put the chain cutters (16) in the direction of the chain
operation.
5. Put the chain in position and make sure that the loop is
behind the guide bar.
15
17
16
6. Hold the chain and bar.
7. Put the chain loop around the sprocket (19).
8. Make sure the chain tension pin hole (20) on the guide
bar fits correctly with the bolt.
19
20
9. Install the chain cover.
10. Tighten the chain. Refer to Adjust the chain tension.
11. Tighten the bar nut when the chain is correctly tensioned.
NOTE
If you start the chain saw with a new chain, have a test for
2-3 minutes. A new chain gets longer after the first use,
examine the tension and tighten the chain if necessary.
7.4 USE THE SHOULDER STRAP
60°MAXIMUM
1. Attach the carabiner to the carrying ring on the pole.
2. Put on the shoulder strap.
3. Adjust the length of the strap so that the carabiner is
about the width of a hand below your right hip.
7.5 ADJUST THE LENGTH OF THE
POLE SAW
7
8
1. Loose the collar (7) by turning it counterclockwise.
2. Pull / Push the telescoping shaft (8) to adjust the length of
the polesaw.
3. Turn the collar clockwise to tight it.
8
English
EN
Loading ...
Loading ...
Loading ...