Alpine PXX5300 Eco-Twist Pump 5300GPH w/ 33 Ft. Cord, 7 Inch Tall

User Manual - Page 5

For PXX5300.

PDF File Manual, 11 pages, Read Online | Download pdf file

PXX5300 photo
Loading ...
Loading ...
Loading ...
4
For more information about our company or products, please visit our website at www.alpine4u.com or call us (USA) 1-877-710-0162
DISMANTLING AND REASSEMBLING
(Figure 2.2)
(Figure 2.3)
WARNING: Always unplug or disconnect all appliances in the pond from the electrical supply before installing,
repairing, maintaining or handling the equipment in the water.
Dismantling (See Figure 2.1 on page 3):
A. Follow the safety instructions. Unplug the power cord.
B. Remove the pre-lter cage (2) from the pump front cover (3).
C. Unscrew the three screws (12) from the counter ring (11).
D. Remove the pump body (9) with the pump front cover (3) from
the handle (10).
E. Remove the six pump housing screws (8). See gure 2.2
F. Remove the pump front cover (3) from the pump body (9).
G. Remove the impeller (5) from the pump body (9). Important
Note: The impeller magnet (5) is powerful and will be pulled back
towards the pump body (9) with great force. Ensure your ngers
do not get clamped in the process. Be careful to not lose the
O-ring (4), it will be attached to the pump body (9).
H. Clean all parts with clear water and a soft sponge or cloth. See
gure 2.3
I. Replace defective parts (if any).
Reassemble (See Figure 2.1 on page 3):
A. Insert the impeller (3) back into the pump body (9) Important
Note: The impeller magnet (3) is powerful and will be pulled
back towards the pump body (9) with great force. Ensure your
ngers do not get clamped in the process. See gure 2.4
B. Replace the O-ring (4) and properly t to the pump body (9).
C. Check whether the impeller (3) can rotate freely.
D. Replace the pump front cover (3) on the pump body (9) and
then evenly tighten the six pump casing screws (8).
E. Replace the pump body (9) with the pump front cover (3) back
in the handle (10).
F. Place the counter ring (11) and screw it back in place using the
three stainless steel screws (12).
G. Place the pre-lter cage (2) back on the pump front cover (3).
H. Restart the pump in water after properly reinstalling all the
components
(Figure 2.4)
Loading ...
Loading ...
Loading ...