Loading ...
Loading ...
Loading ...
8
appliances burning gas or other fuels.
Do not use or leave the hood without
the lamp correctly mounted due to the
possible risk of electric shocks. Never
use the hood without effectively
mounted grids. The hood must NEVER
be used as a support surface unless
specifically indicated. Use only the
fixing screws supplied with the product
for installation or, if not supplied,
purchase the correct screws type.
Use the correct length for the screws
which are identified in the Installation
Guide. In case of doubt, consult an
authorised service assistance centre or
similar qualified person.
WARNING! Failure to install the screws
or fixing device in accordance with
these instructions may result in
electrical hazards. We will not accept
any responsibility for any faults,
damage or fires caused to the
appliance as a result of the non-
observance of the instructions included
in this manual.
This appliance is marked according to the European
directive 2012/19/EC on Waste Electrical and Electronic
Equipment (WEEE). By ensuring this product is disposed of
correctly, you will help prevent potential negative
consequences for the environment and human health,
which could otherwise be caused by inappropriate waste
handling of this product.
The symbol
on the product, or on the documents
accompanying the product, indicates that this appliance
may not be treated as household waste. Instead it should
be taken to the appropriate collection point for the recycling
of electrical and electronic equipment. Disposal must be
carried out in accordance with local environmental
regulations for waste disposal.
For further detailed information regarding the process,
collection and recycling of this product, please contact the
appropriate department of your local authorities or the local
department for household waste or the shop where you
purchased this product.
Appliance designed, tested and manufactured according to:
• Safety: EN/IEC 60335-1; EN/IEC 60335-2-31, EN/IEC
62233.
• Performance: EN/IEC 61591; ISO 5167-1; ISO 5167-3;
ISO 5168; EN/IEC 60704-1; EN/IEC 60704-2-13; EN/IEC
60704-3; ISO 3741; EN 50564; IEC 62301.
• EMC: EN 55014-1; CISPR 14-1; EN 55014-2; CISPR 14-
2; EN/IEC 61000-3-2; EN/IEC 61000-3-3. Suggestions for a
correct use in order to reduce the environmental impact:
Switch ON the hood at minimum speed when you start
cooking and kept it running for few minutes after cooking is
finished. Increase the speed only in case of large amount of
smoke and vapour and use boost speed(s) only in extreme
situations. Replace the charcoal filter(s) when necessary to
maintain a good odour reduction efficiency. Clean the
grease filter(s) when necessary to maintain a good grease
filter efficiency. Use the maximum diameter of the ducting
system indicated in this manual to optimize efficiency and
minimize noise.
Installation
The minimum distance between the supporting surface for
the cooking equipment on the hob and the lowest part of the
range hood must be not less than 50cm from electric
cookers and 65cm from gas or mixed cookers.
If the instructions for installation for the gas hob specify a
greater distance, this must be adhered to.
The template (*) can be used for installation.
Electrical connection
The mains power supply must correspond to the rating
indicated on the plate situated inside the hood. If provided
with a plug connect the hood to a socket in compliance with
current regulations and positioned in an accessible area,
after installation. If it not fitted with a plug (direct mains
connection) or if the plug is not located in an accessible
area, after installation, apply a double pole switch in
accordance with standards which assures the complete
disconnection of the mains under conditions relating to
over-current category III, in accordance with installation
instructions.
Warning! Before re-connecting the hood circuit to the mains
supply and checking the efficient function, always check
that the mains cable is correctly assembled.
Warning! Power cable replacement must be undertaken by
the authorised service assistance centre or similar qualified
person.
Operation
The hood is fitted with a control panel with aspiration speed
selection control and a light switch to control cooking area
lights.
Maintenance
Clean using ONLY the cloth dampened with neutral liquid
detergent. DO NOT CLEAN WITH TOOLS OR
INSTRUMENTS. Do not use abrasive products. DO NOT
Loading ...
Loading ...
Loading ...