Loading ...
Loading ...
Loading ...
TIMER
The appliance will always beon when the slideswitch is inthe“I” position.
The appliance will always beoff when the slide switch is inthe“O” position.
To set the Timer; set the MODE switch to the Timer position.
(This function can only be used once a heat level has been selected ; see thermostat
section).
You must set the time prior to programming the Timer. To do this; turn the outer dial
of the timer in a clockwise direction until the time of the day (24-hour clock)
corresponds with the triangular marking. Example if it is 2pm (1400 hours) then set
the triangular mark in line with 14. One complete turn of the dial corresponds to 24
hours.
There are 96 “riders”, positioned around the dial, each rider represents 15 minutes.
Where all the “riders” are pushed to the outside of the timer the appliance will be ON
continuously.
To set a specific timefor example:
If you want the appliance to be on from 6pmto 10pm, then set all the riders from 18
to 22 (1800 hours to 2200 hours) to the outside of the rim and all other riders to the
inside of the timer. The unit will then turn on automatically at 6pm and off again at
10pm.
Operating Your Heater
Loading ...
Loading ...
Loading ...