Loading ...
Loading ...
Loading ...
20 21
TM
TM
Neato Botvac
™
User Manual Neato Botvac
™
User Manual
If the area is less than about 15’ (4.5 m) x 15’ (4.5 m) it will do a
boundary cleaning of the area and then clean the interior using a
back and forth straight-line pattern.
If the area is larger than 15’ (4.5 m) x 15’ (4.5 m), it will create
a virtual room that is about 15’ (4.5 m) x 15’ (4.5 m) and do a
boundary cleaning and then clean the interior of the virtual
room using a back and forth straight-line pattern. It will move
on to vacuum the next virtual room. Depending on the size and
configuration of the room, it may or may not finish one room
before moving to the next. It will continue to clean in “segments”
until the job is finished, keeping track of where it has and has not
cleaned, using its sophisticated SLAM technology.
STARTING AT THE CHARGE BASE:
If Botvac started at the charge
base and needs to recharge before
finishing the job, it will navigate
back to the charge base, wiggle
up to it and recharge. You will
see a message on the LCD that
says “Cleaning Suspended While
Charging”. It is in suspended
cleaning mode while charging.
Once it recharges Botvac will go back out and resume cleaning
where it left off. Botvac will do a maximum of three cleaning runs
and two recharges between the cleaning runs. After the third
cleaning run it will dock at its charge base and recharge.
0:00
CLEANING
SUSPENDED
WHILE
CHARGING
PAUSE
STARTING OFF THE CHARGE BASE: If Botvac is not started at
the charge base and cannot complete cleaning the area in one
battery charge, it will go back to where it started and ask you to
return it to the charge base to recharge.
It is in suspended cleaning mode
while charging. When finished
charging, place it within two feet of
where it returned for charging, press
START again, and it will return to
where it left off to finish the cleaning
job. It will repeat this one more time
if it hasn’t finished the cleaning job.
CLEAN SPOT
MODE
Spot mode is used to clean a small area. Spot mode will clean a
4’ (1.2 m) x 6’ (1.8 m) area in front of Botvac.
To start Spot mode, put Botvac on
the floor facing the area you want
cleaned. Press the left button – with
the
icon. The screen will show
Botvac is CLEANING Spot.
Botvac will scan the area, turn right
and do a boundary cleaning of a
4’ (1.2 m) x 6’ (1.8 m) area.
It will then clean the interior using a back and forth straight-line
pattern and return to its starting location or if it saw a charge base
while cleaning it will return to the charge base and wiggle up to it.
0:00
CLEANING
Spot
Please
return me
to my base.
OKAY
Loading ...
Loading ...
Loading ...