Loading ...
Loading ...
Loading ...
operation was confirmed
(
page 13).
Inserting the battery
R U
SE ONLY a CR2 Lithium battery.
R Confirm the polarities (
, ).
1 Remove the sensor unit cover.
R Lift from the indented area (A)
and open the sensor unit cover
(B).
1
2
2 Insert the battery.
3 A
ttach the sensor unit cover.
Registering the
window/door sensor
This procedure is not required for
d
evices that were included as part of
a bundle.
Before you can use the window/door
sensor, it must be registered to the hub.
If you purchased devices separately
(i.e., not as part of a bundle), you must
register each device to the hub.
You can register each device by using
the registration buttons or the [Home
Network] app.
Using registration buttons
1 H
ub:
Press and hold M
OTHER
D
EVICEN until the LED indicator
blinks in green.
2 Window/door sensor:
Remove the sensor unit cover and
press and hold M
N
until the
LED indicator blinks in green
(page 7).
R When registration is complete,
the hub sounds one long beep.
Note:
R To cancel without registering the
sensor, press M
N on the hub and
on the sensor again.
R If registration fails, the hub sounds
several short beeps.
Using the app
W
hen you register the window/door
sensor by using the [Home Network]
app, you can assign a name to your
8
Setup
HNS101AZ_(en_en)_0325_ver.031.pdf 8 2015/03/25 14:20:39
Loading ...
Loading ...
Loading ...