Loading ...
Loading ...
EN
Local Operations
Reset the hub:
1.Ensure that the hub has been removed from any previous Sengled
Element accounts. If the hub is still associated with an account:
navigate to the device tab, then delete the hub in question.
2.If there is an Ethernet cable attached to the hub, remove the
cable from the hub. If not, continue to the next step.
3.Power off the hub and then power it back on and wait 30
seconds.Then press and hold the reset button on the side of the
hub for 8 seconds. (User may want to use a pen or pencil.) Please
note, you must wait 30 seconds or the reset process may fail.
4.If successful, the middle LED of the hub will flash eight times.
Rejoin wireless network from the bulb: Power cycle the bulb (off
then back on) five times quickly. The bulb will blink two times
indicating network rejoin.
Reset factory default for the bulb: Power cycle the bulb (off then
back on) quickly for at minimum ten times. The bulb will blink five
times indicating pairing mode.
EZ-Mode commissioning from the bulb: Power cycle the bulb (off
then back on) seven times quickly to enable EZ-Mode. The bulb will
blink to indicate that it is in this mode for three minutes. To exit this
mode earlier, power off the bulb via the wall switch, wait for two
seconds and then power it back on.
*To ensure the following steps work successfully, please power
on the bulb first and wait for at least four seconds before taking
any of the steps.
System Setup Instructions
•
•
Please review the Quick Start guide for instructions on how to
set up the Element Hub
Please contact customer service via Sengled.com for
information on how to purchase additional bulbs. To add
additional bulbs, please follow the in-app instructions to scan,
power on and add the bulbs to their desired hub as shown below
Loading ...
Loading ...
Loading ...