Loading ...
Loading ...
INSTALLATION
ELECTRICAL WIRE CONNECTION
OVERLOAD PROTECTION
Do not work on pump until
power is unplugged.
Do not cut off ground pin or
use an adapter tting.
1. The following may cause injury and/or severe
damage to pump and will void the warranty.
(a) Using an extension cord.
(b) Cutting o the ground pin or using an
adapter tting.
(c) Working on pump or switch while
plugged in.
(d) Removing motor housing, unscrewing
impeller, or otherwise removing
impeller seal.
(e) Running the pump continuously.
(f) Pumping chemicals or corrosive liquids.
(g) Pumpinggasolineorotherammable
liquids
2.Pumpwillbeinadequateifsuspension
liquids contain solid particles larger than 1/8”.
Verify that the voltage and
frequency of the pump shown
onthenameplatecorrespondstothoseavailableon
the mains. The installer must make sure that the
electric system is grounded in accordance with code.
• Foroutdooruseitisnecessarytousecablewith
alengthofatleast8’.Theplugandconnection
shouldbeprotectedfromwatersplashes.Before
using the pump, always inspect it visually
(especiallypowercableandplug)
• Do not use pump if it is damaged
• Ifthepumpisdamaged,haveitinspectedbyan
authorized service center.
• Make sure that electric connections are protected
fromooding.Protecttheplugandthepower
cablefromheatorsharpedges.
Thepowercablemustbe
replacedbyqualiedpersonnel
only.Grounding:Theplugofthepowercablehasa
doublegroundingcontact,sothatgroundingcanbe
performedbysimplyinsertingtheplug.
This pump series has a built in thermal protection
switch. The pump stops if an overload condition
occurs. The motor restarts automatically after it
has cooled down. If it doesn’t start automatically,
unplug the pump and plug it back in.
3
Loading ...
Loading ...
Loading ...