Loading ...
Loading ...
Loading ...
Important
Read these instructions for use carefully and look at the illustrations before using the appliance.
◗ Only use Philips double-layer paper dustbags (FC 8046) or the cotton dustbag provided
(specific types only).
◗ Check if the dustbag has been placed correctly.
◗ Never suck up water or any other liquid. Never suck up flammable substances and do not
suck up ashes until they are cold.
◗ Only allow children to operate the vacuum cleaner under close supervision.
◗ Do not point the hose at the eyes or ears nor put it in your mouth when the vacuum
cleaner is switched on and the hose is connected to the vacuum cleaner.
◗ When the vacuum cleaner is used to suck up fine dust, the pores of the dustbag may become
clogged, causing the passage of air through the dustbag to become obstructed.As a result, the
dustbag-full indicator will indicate that the dustbag needs to be replaced, even though the
dustbag is not full at all.
◗ Never use the appliance without the motor protection filter.This could damage the motor
and shorten the life of the appliance.
◗ Noise level: Lc= 83dB(A)
Connecting accessories
1 Connect the hose to the appliance by firmly pushing the side with the connector switch into
the appliance (fig. 1).
2 Connect the tube to the handgrip by inserting the narrow section into the wider section
while turning it a little (fig. 2).
- You can connect the combi nozzle, the crevice nozzle, the round brush or the small nozzle in
the same way.
- To disconnect the tube and accessories, pull while turning a little.
◗ The combi nozzle can be used on carpets (with the brush strip folded in) and on hard floors
(with the brush strip folded out).
3 Connect the combi nozzle to the tube.
4 To clean hard floors, push the appropriate rocker switch on top of the combi nozzle with
your foot to make the brush strip come out of the nozzle housing (fig. 3).
5 To clean carpets, push the appropriate rocker switch to make the brush strip disappear into
the combi nozzle housing.
6 Lift the handle on the vacuum cleaner to gain access to the accessory storage compartment.
7 The crevice nozzle can be connected to the tube or to the handgrip (fig. 4).
Using the appliance
Vacuum cleaning
1 Pull the cord out of the appliance and put the mains plug in the wall socket.
2 Switch the appliance on by pushing the on/off button on top of the appliance with your foot
(fig. 5).
Adjusting suction power
You can adjust the suction power while vacuum cleaning.
1 Adjust the suction power by means of the slide on the handgrip (fig. 6).
ENGLISH6
Loading ...
Loading ...
Loading ...