Loading ...
Loading ...
Loading ...
Your steam generator has been designed to operate using untreated tap water.
If your water is very hard, mix it 50 % untreated tap water with 50 % distilled water.
Do not use water from clothes dryers, scented water, water from refrigerators, water from air conditioners or rain
water.Also do not use filtered, boiled or bottled mineral water.These contain organic waste or mineral elements
that become concentrated when heated and cause spitting, brown staining or premature wear to your iron.
3. PREPARING YOUR STEAM GENERATOR
1. To carry your steam generator by the iron handle:
- place the iron on the iron rest of the generator and raise the retaining hoop over the iron
until it locks into place (audible click) (1).
- grasp the handle of the iron to carry your steam generator (2).
2. Place your steam generator on a stable, horizontal heat-resistant surface.
3. Check that your appliance is disconnected and cold.
4. Unscrew the boiler cap.
5. Using a water jug, fill with maximum 1/2 litre of water.
6. Fill the boiler, taking care that the water does not spill over (3).
If this occurs, remove the excess water.
7. Replace the boiler cap, screwing on tightly.
Type of water to use ?
Types of water to be avoided ?
1. UNDERSTANDING YOUR STEAM GENERATOR
English
1- Iron retaining hoop
2- Iron rest
3- Boiler cap
4- Boiler (inside the base-unit)
5- Steam indicator
6- Illuminated on/off switch O/I
7- Thermostat light
8- Temperature control slide for the iron
19- Steam control button
10- Power cord fastener clip
11- Power cord
12- Steam cord
13- Steam cord fastener clip
2- LOCKING SYSTEM FOR RETAINING THE IRON ON THE
BASE
ENG
Your steam generator is equipped
with a retaining clip which locks
the iron on its casing for easier
transport and storage
UnlockLock
Loading ...
Loading ...
Loading ...