Loading ...
Loading ...
Loading ...
Consumer SupportTroubleshooting TipsOperating InstructionsSafety Instructions Installation Instructions
Assemble the Supports
Loosely attach a support bracket to a support
rail using 2 Type C screws.
NOTE: The support bracket may be attached into
either slot in the support rail, depending on the depth
of your window sill.
Thread a nut onto a leveling bolt, then
thread the leveling bolt into the support
bracket. An adjustable wrench may be needed.
Before attaching the support, hold the neck of
the support rail against the back edge of the
window stool.
Adjust the position of the support bracket
inward or outward on the support rail until the
leveling bolt is near the outside edge of the sill.
NOTE: Make sure that the leveling bolt will be firmly
supported by the sill.
Tighten the Type C screws to secure the
support bracket to the support rail in the
correct position.
Repeat steps A–E to assemble the second
support.
F
E
D
C
B
A
8
Install the Supports
Line up the V-notches in the support rails with
the left and right marks on the stool. Make
sure that the support rail is against the back
of the stool and drill two 1/8″ pilot holes into
the stool through the holes in the head of the
support rail. Attach the supports to the stool
using two Type B screws in each support.
Adjust the leveling bolts against the sill so that
the supports have a slight tilt to the outside.
Use a level; about 1/2 bubble will be the
correct slant to the outside. After leveling is
done, tighten the leveling bolt nut.
NOTE: Use a steel washer between the leveling
bolts and the sill if the sill is weak.
Attach the adhesive side of the window stool seal
(thick, adhesive-backed) to the window stool.
C
BA
9
Type C screws
Support bracket
Support rail
Support bracket
Leveling bolt
Nut
Adjust as
needed
Neck of
support rail
Stool
Supports
Sill
Type B
screws
Stool
1/2 bubble
Leveling bolt
Nut
15
Window stool seal
Loading ...
Loading ...
Loading ...