Loading ...
Adjust Aeration Screw in Burners
Adjustment must be carried out for each of the burners.
Low flame At the air entry side of each burner release and
turn the aeration screw anticlockwise until no thread is
protruding into the burner and lock to place with the locking
nut. Do not completely remove the screw.
Replace all parts into position in the BBQ.
Refit the burners and secure with the locking clips that hold
each burner is position. Replace the cooking plate.
NOTE: Check the operation of each burner.
Gas Leak Test Procedure
Use the following procedure to check for gas leaks. Never
use a naked flame to check for gas leaks.
1. In a small container, mix up a solution of water and
detergent or soap. Mix the solution well.
2. For LPG make sure that the gas supply valve on the gas
cylinder is turned on. For NG make sure that the gas
line is correctly fitted to the appliance.
3. Make sure that the gas control valves on the appliance
are all turned off.
4. Using a brush or spray bottle apply the solution to the
gas line and each join in the gas line.
5. Bubbling of the solution will indicate that there is a leak
present.
6. Re-tighten or re-seal any joints that are leaking.
7. If a leak persists then contact your distributor or the
manufacturer for assistance.
Use the following procedure to test the pressure.
8. Remove the far left burner.
9. Place a hose and pressure gauge over the control
valve’s injector.
10. Turn all other burners on, including the side burner.
11. Turn the LH valve with measuring device on as well,
and take reading.
12. With a minimum of 3 burners operating, the pressure
reading for Natural Gas should be 1.00KPa (10 mbar).
Replace the Data Label
Peel the gas type label from backing and cover existing data
label to indicate Natural Gas.
WARNING
WARNING
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. Open lid.
4. If odour continues, immediately call your gas supplier or
your fire department.
WARNING
WARNING
1. Do not store or use gasoline or other flammable vapours
or liquids in the vicinity of this or any other appliance.
2. An LPG cylinder not connected for use shall not be
stored in the vicinity of this or any other appliance.
Technical Data Discovery BBQ
Inlet pressure Main Burner Side Burner
NG: 1KPa 1.9mm NG 1.7mm NG
LPG: 2.75 KPa 1.15mm LPG 1.05mm LPG
17Mj 15Mj
NOTE: To convert the BBQ from Natural Gas to LPG, all of
the steps must be reversed including the replacement of the
data label. Correct spanner to be used with these injectors is
9/32” or 3BA.
NATURAL GAS CONVERSION INSTRUCTIONS
BD95184K
© 2017 Electrolux Home Products Pty Ltd. ABN 51 004 762 341
BMAN_DISC_GASCONV_Oct17
For more information on all BeefEater products, or for
dimension and installation information, call into your retailer,
phone or email our customer care team or visit our website:
AUSTRALIA
phone: 1300 307 939
fax: 1800 356 669
email: customercare@electrolux.com.au
web: beefeaterbbq.com
NEW ZEALAND
phone: 0800 436 245
fax: 0800 225 088
email: customercare@electrolux.co.nz
web: beefeaterbbq.com