Loading ...
Loading ...
Loading ...
USE
• Only operate the steamer on the floor clear of any materials which may obstruct the
base of the steamer (flat and horizontal surface). Do not obstruct the openings on the
lower part of the appliance. This appliance should not be used on very thick carpets or
rugs.
• Undo the Velcro strip and completely unwind the electrical cord. (fig.10)
• Plug in to power socket. (fig.11)
• Switch on by pressing the pedal located at the front of the appliance. The power indi-
cator light will come on. (fig.12)
• The appliance will begin producing steam after approximately 60 seconds.
• Hang the garments from the built-in hanger or from another hanger which may be sus-
pended from the hook located on the hanger rod. To steam trousers, we recommend
that you also use the support with clips as indicated in the illustration. (fig.14)
• Grasp the steam head with the steam vents pointing away from you.
• Start steaming by brushing material lightly with the grain of the fabric in an up/down
vertical motion. The fabric brush opens the weave of the fabrics for better steam pene-
tration.
• Start at the top the garment and gradually move downward (fig.13). Always steam in a
vertical position.
• For more ease, we recommend to pull the garment downward with your free hand while
steaming. Be careful not to touch the hot steam.
• During use, the hose may make a gurgling noise. This is a normal occurrence due to
condensation. If the appliance begins to gurgle, rest the steam head on its support for
a few moments in order to direct the condensation into the appliance once again.
ACCESSORIES
Before using an accessory, check the manufacturer recommendations.
It is also recommend that you carry out a test on part of the fabric which cannot be seen.
Fabric brush
The fabric brush opens the weave of the fabrics for better steam penetration.
• Attach the fabric brush to the steam head by li-
ning up the bottom of the brush with the bot-
tom of the steam head. Gently push the top of
the brush onto the steam head until it clicks
into place.
• Gently brush the area to be steamed with the
grain or nap of the fabric.
• Remove the fabric brush once unit is unplug-
ged and completely cool. Remove it by pres-
sing on the release tab on top of brush while pulling it forward.
Warning: Never steam a garment while it is being worn.
The flexible pipe and the end of the steam head can become extremely hot during
use. This is perfectly normal. Be careful and avoid any prolonged contact.
Be sure unit is unplugged and completely cool before attaching accesories.
14
9100021246-01 IS6200 M2-D2.qxp_110X154 08/07/2016 10:38 Page14
Loading ...
Loading ...
Loading ...