Loading ...
Loading ...
Loading ...
en
43
Fault Possible cause Remedial action
The temperature in the
freezer section is too warm.
Appliance opened
frequently.
Do not open the appliance unnecessarily.
The ventilation openings
have been covered.
Remove obstructions.
Large quantities of fresh
food are being frozen.
Do not exceed the freezing capacity.
A warning signal sounds.
The 6 alarm button lights up.
Fault - the freezer section is
too warm!
To switch off the warning signal, press 6 alarm
button.
Appliance is open. Close the appliance.
Ventilation openings are
covered up.
Ensure that there is adequate ventilation.
Too much food was placed in
the freezer at once.
Do not exceed the freezing capacity.
When the fault has been eliminated, the alarm
button goes out shortly afterwards.
The light does not function. The LED light is defective. See chapter “Light (LED)” section.
Appliance was open too
long.
Light is switched off after
approx. 10 min.
When the appliance is closed and opened,
the light is on again.
Controls have reduced
luminosity.
When the appliance is not
used for some time,
the display on the fascia
switches to energy saving
mode.
As soon as the appliance is again used, e.g.
the door is opened, the display switches back
to normal illumination.
Displays do not illuminate. Power failure; the fuse has
been switched off; the mains
plug has not been inserted
properly.
Connect mains plug. Check whether the power
is on, check the fuses.
Appliance is not cooling,
temperature display and light
are lit.
Showroom mode is
switched on.
Hold down temperature selection button
fig. "/2 for 10 seconds until
an acknowledgement signal sounds.
After a short time check whether your
appliance is cooling.
Loading ...
Loading ...
Loading ...