Loading ...
Loading ...
Loading ...
Page 6
INSTALLATION GUIDE
1. Unpack your refrigerator by removing all packaging materials like carton, base,
foams, adhesive tape, etc.
2. Remove all accessories, internal packaging material used to hold shelves, ice tray,
etc. in place.
3. Clean the remains of all adhesive tap used and remove all printed material
supplied.
4. Install the refrigerator in a convenient location away from extreme heat and
cold. Allow sufcient clearance between the refrigerator and side wall so the
door(s) will open without obstruction. Refrigerator is not designed for recessed
installation.
5. The oor on which the refrigerator should be placed must be at, hard, solid, and
even. The refrigerator should not be placed on any soft material such as foam,
plastic, etc.
6. To level your refrigerator, use the two leveling legs located on the bottom front
of your refrigerator. Adjust by turning the legs counter clockwise to raise or
clockwise to lower your refrigerator. The door will close easier if the leveling legs
are extended.
7. The following are recommended minimum clearances around the refrigerator for
proper air circulation:
Sides: 3/4” (19mm)
Top: 2” (50mm)
Back: 2” (50mm)
Proper air circulation will help your refrigerator work at maximum efciency.
NOTE: · The appliance must be correctly connected to the power supply.
WARNING
It is important to keep the power cord away from the compressor at the
back of the refrigerator as during operation, the compressor can reach a high
temperature and could cause serious damage to the power cord.
SET UP & USE
Loading ...
Loading ...
Loading ...