Loading ...
Loading ...
Loading ...
7-10 Starting and operating
mitter within a few seconds immediately
following remote engine start shutdown.
Pre-heating or pre-cooling
the interior of the vehicle
Before exiting the vehicle, set the temper-
ature controls to the desired setting and
operation. After the system starts the vehi-
cle, the heater or air-conditioning will acti-
vate and heat or cool the interior to your
setting.
Service mode
In service mode, the remote start function
is temporarily disabled to prevent the sys-
tem from unexpectedly starting the engine
while being serviced.
T To engage the service mode
Turn the ignition switch to the “ON” posi-
tion, depress and hold the brake pedal
then, press and release the “ ” button
on the remote control transmitter three
times. The system will pause for one sec-
ond and then flash the parking lights and
honk the horn three times indicating that
the system is in service mode. When at-
tempting to activate the remote start sys-
tem while in service mode, the parking
lights will flash and the horn will honk two
times and will not start.
T To disengage the service mode
Turn the ignition switch to the “ON” posi-
tion, depress and hold the brake pedal,
then press and release the “ ” button
on the remote control transmitter three
times. The system will pause for one sec-
ond and flash the parking lights one time
indicating that the system has exited ser-
vice mode.
NOTE
When taking your vehicle in for ser-
vice, it is recommended that you in-
form the service personnel that your
vehicle is equipped with a remote con-
trol start system.
Remote transmitter program-
ming and programmable fea-
ture option
New transmitters can be programmed to
the engine starter system in the event that
remote transmitters are lost, stolen or
damaged. The remote engine start sys-
tem also has one programmable feature
that can be adjusted for user preference.
The remote engine starter system can be
programmed to either make an audible
horn chirp upon remote start activation or
not. Remote transmitter programming and
feature programming can be adjusted us-
ing the following procedure.
1. Open the driver’s door (the driver’s
door must remain opened throughout the
entire process).
2. Insert the key into the vehicle’s ignition
switch and turn to the “ON” position.
3. Locate the small black programming
button behind the fuse box cover, on the
driver’s side left under the dashboard pan-
el.
4. Press and hold the black programming
button for 10-15 seconds. The horn will
honk and the parking lights will flash three
times to indicate that the system has en-
tered programming mode. At this point
you can perform either action (Step 5 or
Step 6).
5. To program a remote transmitter: press
and release the “ ” button on each
transmitter. The horn will honk and the
parking lights will flash one time to indi-
cate a successful transmitter learn each
time the “ ” button is pressed. You
can program up to eight transmitters.
6. To toggle the Horn Confirmation chirps
ON/OFF: press and release the brake to
toggle the feature. The horn will chirp and
the parking lights will flash one time to in-
dicate Confirmation Horn Chirps are
“OFF”. The horn will honk and the parking
lights will flash 2 times to indicate Confir-
mation Horn Chirps are “ON”. Pressing
A3120BE-B.book 10 ページ ２００６年５月３０日 火曜日 午前９時３２分
Loading ...
Loading ...
Loading ...