Loading ...
Loading ...
Loading ...
Install back panel
Slide back panel down into extrusions.
Install top cover
1. Install screws securing top mount to frame using a Phillips screwdriver.
QtyDescription
6Screw1
1Top mount2
1Back panel3
2. Install screws securing top rear cover to frame using a Phillips screwdriver.
QtyDescription
4Screw1
1Top rear cover2
Securely anchor machine to floor
Owner should not allow equipment to be used until it is properly anchored as described below.
WARNING: Anchoring equipment:
• To maximize stability and eliminate rocking, tipping, or falling over, equipment must be anchored to a
solid, level surface, utilizing all anchoring holes provided.
• Fasteners must have a minimum of 500 lbs. tensile capacity. Cybex recommends .3/8” grade 2 bolts or
better. A minimum pull force of 220 lbs/100 kgs is required for each anchor position.
• If leg frames do not contact surface, DO NOT pull down with anchors. Shim any leg or frame not in contact
with surface using flat washers.
• Due to the wide variation of flooring on which machines may be anchored or installed, consult with a
qualified and licensed contractor to ensure proper anchoring and installation.
Verify proper operation
Page 15 of 23
Loading ...
Loading ...
Loading ...