Loading ...
Loading ...
Loading ...
43
US
Additional Information
MHC-V50.US.4-689-515-14(1)
“OVER CURRENT” appears on the
display.
••
A problem has been detected
with the level of electrical current
from the
(USB) port. Turn off
the system and remove the USB
device from the port. Make sure
there is no problem with the USB
device. If this display pattern
persists, contact your nearest Sony
dealer.
Erroneous display.
••
The data stored in the USB
device may have been corrupted,
perform the transfer again.
••
The character codes that can be
displayed by this system are as
follows:
•—
Upper cases (A to Z)
•—
Numbers (0 to 9)
•—
Symbols (< > * +, [ ] \ _)
Other characters appear as “_”.
The USB device is not recognized.
••
Turn off the system and reconnect
the USB device, then turn on the
system.
••
Check the information on the
website about compatible USB
devices (page10).
••
The USB device is not working
properly. Refer to the operating
instructions of the USB device on
how to deal with this problem.
Playback does not start.
••
Turn off the system and reconnect
the USB device, then turn on the
system.
••
Check the information on the
website about compatible USB
devices (page10).
Playback does not start from the
first file.
••
Set the play mode to Normal Play
(page19).
Files cannot be played back.
••
USB devices formatted with file
systems other than FAT16 or FAT32
are unsupported.*
••
If you use a partitioned USB
device, only files on the first
partition can be played back.
* This system supports FAT16 and FAT32,
but some USB devices may not support
all of these FAT. For details, refer to the
operating instructions of each USB
device or contact the manufacturer.
Tuner*
There is severe hum or noise, or
stations cannot be received.
••
Connect the antenna properly.
••
Change antenna location and
its orientation to obtain good
reception.
••
Turn off nearby electrical
equipment.
* Radio may not be received depending
on the radio wave conditions or the
housing environment in your area.
BLUETOOTH device
Pairing cannot be performed.
••
Move the BLUETOOTH device
closer to the system.
••
Pairing may not be possible if
other BLUETOOTH devices are
present around the system.
In this case, turn off the other
BLUETOOTH devices.
••
Make sure to enter the correct
passkey when selecting the
system’s name (this system) on
the BLUETOOTH device.
The BLUETOOTH device cannot
detect the system, or “BT OFF”
appears on the display.
••
Set the BLUETOOTH signal to “BT
ON” (page29).
Loading ...
Loading ...
Loading ...