Loading ...
Loading ...
Loading ...
Page 11
Operating Instructions
Operating the Deluxe Panini Grills equipped with Timers
(GPG14D, GSG14D, GPGDUE14D, and GSGDUE14D)
Panini grills equipped with timers can be programmed and store up to four (4) different cooking times. Timers can
be set from 5 seconds to 15 minutes.
Setting up the timers
1. Make sure the unit is plugged in and turned on. Use the temperature dial to set the desired temperature.
On deluxe double units, make sure the temperature dial is turned on for each grill surface.
2. Press the number 1 located on the touch pad of the grill until the LED display begins to blink.
3. Press the up or down arrow keys to the desired time of your rst timer.
4. Once the time is reached, leave the grill untouched until the display stops blinking OR press the number
“1” timer one time so the display stops blinking.
Timer selection, number 1 is now programmed.
Repeat the steps above, using the number of the timer to be programmed, to set timers 2 through 4.
Once the grill timers have been set and the cooking temperature of the grill has been reached, it is now ready for
use.
Using the Preset Timers
1. Make sure the unit has reached the desired temperature.
2. Place food on open grill and use the handle to close top plate.
3. Press one of the four numbers containing the times that have been previously set.
4. Press the “Start” button located next to the LED display. (In order for your time to begin counting down,
the start button MUST be pressed each time a timer is selected.)
The timer will begin to count down. Once time reaches the zeros, the LED display will blink 00:00 and ve
quick ‘beeps’ will indicate that the timer has nished its cycle.
5. Tend to the food being prepared.
Repeat steps 1-5 as many times as necessary.
Note: To restart the same time as previously used, press the “Start” button again. The timer number selection does
not have to be chosen again.
• To interrupt a descending cycle time, press “Stop”. The LED display will then blink with the time remaining.
(Note: When its cycle is interrupted, time cannot be added to the timer once the timer begins to countdown)
• To continue a descending cycle time from where it left off, press the “Start” button.
• If you need to restart a time from the beginning, stop the current timer cycle. Then, select one of the preset
timers (1-4) and press the “Start” button.
To reprogram or change a timer’s preset time, follow the instructions under “Setting up the timers”.
Note: If the unit loses power, is turned off or is unplugged from the power source, the previously set times of the
timers are retained.
Loading ...
Loading ...
Loading ...