Loading ...
Loading ...
Loading ...
11
Simmer Burner
The SIMMER burner gives you a choice of simmer settings from SIMMER to HIGH. The SIMMER setting can be used to
gently melt chocolate and hold delicate sauces at low temperatures.
For the lowest simmer setting, push in and turn the knob to HIGH to ignite the burner, then turn counter clockwise to
the SIMMER setting on the knob.
o For burners without the SIMMER setting marked on the control knob, push in and turn the control knob to
HIGH to initially ignite the burner, then turn the knob counterclockwise past the LOW indicator until the knob
stops.
For best simmer results only use the simmer burner. To locate the simmer burner on your range, reference the
burner configuration in the beginning of this manual. The simmer burner is located in the back left position of most
ranges.
TOP GRATES
TIP: When placing the top grate back on the cooktop, locate the pin on the bottom of the grate and place inside the
positioning holes of the cooktop.
Your top grates may darken over time with use. This is normal.
TIP: To prevent your burners from darkening at an uneven rate, rotate top grates between more and less active burners.
BURNER CLEANING
Top Grates
TIP: Clean spills as soon as possible to prevent sticking and build up.
When burner is cool, remove the ring grate, top grate and center filler grate (30” models only).
Wash in hot, soapy water. Rinse well and dry thoroughly to prevent rusting.
Handle gently to prevent nicks/chips, which can lead to rusting
TIP: If you have a nick or chip you can season the area to prevent rusting. Nicks or chips are not covered under warranty.
Put corn oil or other high smoke point oil on a paper towel and rub onto rusted area.
Wipe away excess oil and replace the part on the range.
Do not submerge the burner grates in water for extended periods of time. Prolonged exposure to moisture
may cause rusting
For heavy soiling, use a commercially available oven cleaner. Follow the cleaner manufacturer’s
instructions.
Make sure the cleaning chemicals do not contact any stainless steel or painted surface on your
appliance.
Reinstall grates in cooktop and make sure they are seated properly, and do not move unsteadily from side
to side.
Burner Caps
Burner caps locations are specific to the valves on the front of the unit. If burner caps are removed for
cleaning or other purposes, they must be re-installed in the same location they were removed from.
Failure to do so may result in a burner that will not light or possibly have a high flame.
CAUTION
ATTENTION
ATTENTION
ATTENTION
Loading ...
Loading ...
Loading ...