Loading ...
Loading ...
Loading ...
Installation and connection en
7
Depending on the model, the adhesive seal may be
factory-fitted. If this is the case, it should not be
removed under any circumstances, since the adhesive
seal prevents leaks. If the seal has not been factory-
fitted, apply it to the underside of the hob.
Fitting the appliance onto the kitchen unit:
1. Screw each one of the clips into the position
indicated so that they are free to rotate.
2. Insert and centre the hob.
Press the sides of the hob until it is supported
around its entire perimeter.
3. Turn the clips and tighten them fully.
The position of the clips depends on how thick the
work surface is.
Do not stick the hob onto the worktop with silicone.
a - b
c
Electrical connection
An electrical 10 amp socket needs to be within 1 m of
the hotplate to allow electrical connection. The socket
must remain accessible after installation of the
appliance.
Important notes:
■ This appliance is connected to the mains (240 VAC)
by means of the connecting lead which must be
fixed to the kitchen unit to prevent it from coming
into contact with hot parts of the cooktop (or an oven
installed underneath) and remain accessible after
installation of the cooktop.
When making this connection make sure that the
lead cannot come into contact with hot parts of the
cooktop.
■ This appliance must be earthed. When connecting
the cooktop ensure that the earth wire is connected
first and that all wires are connected to the correct
terminals.
Wiring diagram
A Switch
B Blue wire
C Brown wire
D Terminal
E Ignition module
[
[
[
/
9
9
1
99
a
Loading ...
Loading ...
Loading ...