Loading ...
Loading ...
Loading ...
16
The appliance must be connected to the water mains using new hose-sets.
The old hose-sets should not be reused.
Water pressure must be between 0,04 MPa and 1 MPa. If the pressure is below the
minimum consult our Service Department for advice.
Pull The safety supply hoses completely out from storage compartment located at rear
of dishwasher.
2.Tighter the screws of the safety supply hose to the faucet with thread 3/4inch.
3.Turn water fully on before starting the dishwasher.
1.
WARNING!
How to connect the safety supply hose
About the safety supply hose
Drain hose Connection
The safety supply hose consists of the double walls. The hose's system guarantees its intervention by blocking the flow
of water in case of the supply hose breaking and when the air space between the supply hose itself and the outer
corrugated hose is full of water.
A hose that attaches to a sink spray can burst if it is installed on the same water line as the dishwasher. If your sink has
one, it is recommended thet the hose be disconnected and the hole plugged.
1.Turn off the water.
2.Release the water pressure by depressing the pressure release button. This relieves water pressure and protects you, and the
room, from severe splashing.
3.Unscrew The safety supply hose from the faucet..
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time, let the water run to make sure that the
water is clear and free of impurities. If this precaution is not taken, there is a risk that the water inlet can get blocked and
damage the appliance.
MAX 1000mm
A
Counter
Front
Drain pipe
NOTE
The top of the hose
must be less than
1000mm.
40mm
B
PLEASE HANG UP THE DRAIN HOSE EITHER WAY OF A, B
How to disconnect the safety supply hose
COLD WATER CONNECTION
Loading ...
Loading ...
Loading ...