Loading ...
Loading ...
Loading ...
26
English
3103 306 18501
Timer Setting
The system can switch on to CD, TUNER, or
TAPE mode automatically at a preset time,
serving as an alarm to wake you up.
IMPORTANT!
– Before setting the timer, ensure that the
clock is set correctly.
– The timer will always be switched on
after it has been set.
– The timer will not start if a recording is in
progress.
– The volume of the timer will increase
gradually from the minimum level to the
last tuned volume level.
1 Press and hold TIMER on the remote control
for more than two seconds.
➜ "AM 12:00" or "00:00" or the last timer
setting starts flashing.
➜ TIMER starts flashing.
➜ The selected source will be lighted while
other available sources are flashing.
2 Press CD 1•2•3, TUNER or TAPE to select
the desired source.
● Before setting the timer, make sure the music
source has been prepared.
CD 1•2•3 – Load the disc(s). To start from a
specific track, make a programme (refer to “CD
Operation - Programming the disc tracks”).
TUNER – tune to the desired radio station.
TAPE – load a prerecorded tape.
3 Press à or á repeatedly to set the hour for
the timer to start.
4 Press í or ë repeatedly to set the minute for
the timer to start.
5 Press TIMER to store the start time.
➜ "TIMER ON" is displayed, followed by the
set timer "XX:XX" and the selected source.
➜ TIMER remains on the display.
● At the preset time, the selected sound source
will play.
To exit without storing the setting
● Press Çon the system.
Notes:
– If CD is the selected source and it is not
available when the preset time is reached, Tuner
will be selected automatically.
– During timer setting, if no button is pressed
within 90 seconds, the system will exit timer setting
mode automatically.
Checking the timer
● Press TIMER on the remote control.
➜ If the timer has been activated, the set timer
information is displayed.
Activating/deactivating the timer
● Press TIMER ON/OFF repeatedly on the
remote control.
➜ If activated, the last set timer information is
displayed for a few seconds, TIMER is shown.
➜ If deactivated, “OFF” is displayed.
Sleep timer setting
The sleep timer enables the system to switch to
standby mode automatically at a preset time.
1 Press SLEEP on the remote control repeatedly
to select a preset amount of time.
➜ The selections are as follows (time in
minutes):
15 ™ 30 ™ 45 ™ 60 ™ OFF ™ 15 …
➜ "SLEEP XX" or "OFF" is displayed. "XX" is
the time in minutes.
2 When you reach the desired length of time, stop
pressing the SLEEP button.
➜ SLEEP is shown, except for "OFF" mode.
➜ The Sleep Timer is now set. Before the
system switches to standby mode, a countdown
of 10 seconds is displayed.
"SLEEP 10" ™ "SLEEP 9".... ™
"SLEEP 1" ™ "SLEEP"
Clock/Timer
pg 001-030/MC77/22-Eng 4/16/02, 10:04 AM26
Loading ...
Loading ...
Loading ...