Loading ...
Loading ...
Loading ...
3
EN
• Fit the required accessory on to the end of the tube:
- For rugs and carpets: use the multi-surface nozzle (23) in the retracted brush position - fig. 5, or the mini Turbo-
brush* (26).
- For parquets and smooth floors: use the multi-surface nozzle (23) in the extended brush position - fig. 6 or, for
best results, directly use the parquet nozzle* (25).
- For corners and hard-to-reach areas: use the crevice nozzle (22).
- For furniture and fragile surfaces: use the upholstery nozzle* (24).
Warning! Always switch off and unplug your vacuum cleaner before changing the accessories
Plugging in the power cord and switching on the appliance
• Unwind the power cord completely, plug in your vacuum cleaner - fig. 7 and press the ON/OFF pedal (13) - fig. 8.
• Adjust the suction power:
- with the electronic power control* (14): turn the electronic control button* to adjust the suction power: towards
the max position for floors and to the min position for furniture and delicate fabrics - fig. 9.
- with the grip's manual power control: open the shutter of the adjustable slider to manually decrease the suction
power, e.g.: on fragile surfaces etc. - fig. 10.
Storing and transporting the appliance
• After use, switch off your vacuum cleaner by pressing the ON/OFF pedal (13) - fig. 8 - and unplug it - fig. 11.
• Rewind the power cord by pressing the power cord rewind pedal (15) - fig. 12.
• Place the multi-surface nozzle (23) in the self-standing position - fig. 13.
• Your vacuum cleaner can be easily moved thanks to its transport handle (1).
Important: Always switch off and unplug your vacuum cleaner before carrying out maintenance or cleaning.
Changing the bag
• The full bag warning light (12) indicates that the bag is full or saturated.
If you notice a reduction in the efficiency of your appliance, set the power at maximum and hold the nozzle above
the ground. If the full-bag warning light remains red, replace the bag.
• Remove the flexible pipe (27) from the suction inlet (11) - fig. 2.
• Open the lid (10) of your vacuum cleaner - fig.14.
a) If your vacuum cleaner is equipped with a paper bag*:
• remove the bag base (6) from the bag compartment (3) - fig. 15, and then remove the paper bag (7) from its
base (6) by sliding it on the runners - fig. 16;
• throw the paper bag in a dustbin - fig.17;
• put a new paper bag on the bag base - fig. 18, and then using the bag base runner (5), place it inside the com-
partment - fig. 19;
• make sure that the paper bag and the bag base are correctly positioned before closing the lid (10).
b) If your vacuum cleaner is equipped with a cloth bag*:
• remove the bag base (6) from the bag compartment (3) - fig. 15, and then remove the cloth bag (8) from its
base (6) by sliding it on the runners - fig. 16;
• open the bag using the retaining clip - fig. 20, and then empty it over a dustbin - fig. 21;
• clean the bag in clean water - fig. 22;
• leave it to dry for at least 24 hours (only refit the bag when it is completely dry);
• close the cloth bag: make sure that the retaining clip is correctly repositioned before refitting the bag in the ap-
pliance;
5. CLEANING AND MAINTENANCE
* Model dependent: these parts are specific to certain models or they are accessories that can be purchased separately.
TE_TW22_903513-01_micro-space_903513/01 17/04/14 09:21 Page3
Loading ...
Loading ...
Loading ...