GE - General Electric PKD915BMBB GE Profile 27" Warming Drawer

User Manual - Page 13

For PKD915BMBB.

PDF File Manual, 24 pages, Read Online | Download pdf file

PKD915BMBB photo
Loading ...
Loading ...
Loading ...
13
Safety Instructions Operating Instructions Care and Cleaning Installation Instructions Troubleshooting Tips Consumer Support
When installed, the front face of the warming
drawer will be nearly flush with cabinetry doors
or drawer fronts.
Drawer overlaps will conceal cut edges on
all sides of the opening.
The rough opening for the drawer must be:
—Depth: 23
1
2 minimum from inside back
to front of cabinet frame.
—Width: 25
1
2 for 27 wide models
28
1
2 for 30 wide models.
—Height: 9
1
4
Allow 2 minimum between oven and drawer
cutouts for clearance of overlaps.
NOTE: If you are installing in frameless cabinets,
it may be necessary to install 1/2 wide cleats to
accept drawer mounting screws. See drawer to
find exact locations of mounting screws.
When installed under a wall oven:
Warming drawers are suitable for installation
below only certain specified wall oven models.
See the label attached to the top of the warming
drawer for suitable models.
NOTE: Electrical receptacle can be installed
as shown for countertop installations. Do not
install receptacle above the top of the warming
drawer cutout.
23
1
2
Min.
2x2 or 2x4 anti-tip
block against rear
wall 9” from floor
to bottom of block
1 Min. above toekick or adjust
to oven installation height
A
NOTE: Additional clearance between cutouts may
be required. Check to be sure that oven supports
above the warming drawer location do not obstruct
the required interior 23
1
2 depth and 9
1
4 height.
Installation below a single oven
2 Min
1 Min. above toekick
NOTE: Additional clearance between cutouts may
be required. Check to be sure that oven supports
above the warming drawer location do not obstruct
the required interior 23
1
2 depth and 9
1
4 height.
Installation below a double oven
Dimension A Dimension B
27 Drawer 25
1
2 26
3
4
30 Drawer 28
1
2 30
2x2 or 2x4 anti-tip
block against rear
wall 9” from floor
to bottom of block
2 Min.
Allow 5/8”
overlap on
all sides
10
1
2
23
1
2
Min.
Allow 5/8 overlap
on all sides
A
23
1
4
10
1
2
9
9
1
4
23
1
4
Installation Below Wall Ovens
Read these instructions completely and carefully.
9
9
1
4
B
Oven
cutout
Oven
cutout
B
WARNING!
IN CANADA THE WALL OVEN
IS ONLY APPROVED FOR
INSTALLATION WITH A BOTTOM
CUTOUT AT A MINIMUM OF 32.5"
FROM THE FLOOR.
WARNING!
IN CANADA THIS DRAWER IS NOT APPROVED
FOR INSTALLATION UNDER A DOUBLE OVEN.
Loading ...
Loading ...
Loading ...