Loading ...
Loading ...
Loading ...
9
IMPORTANT: If the iron is
set to a low temperature
on the Temperature
Control (i.e. synthetic
or silk) and also on any
of the steam control
settings, there may
be leakage from the
soleplate. This is due to
the iron temperature not
being high enough to
vaporise the water and
create steam.
Therefore, ensure that
the steam control is
always set to correspond
with the setting on the
temperature control as
seen in Table A
(see section ‘Setting
the Temperature’).
How To Use Shot Of Steam
The shot of steam provides an extra burst
of steam which is ideal for the removal
of stubborn creases and wrinkles during
STEAM or DRY ironing.
Turn the Temperature Control to the
hottest setting and wait until the heating
indicator light goes out. Ensure the Steam
Control corresponds to the setting on the
Temperature Control.
Lift the iron slightly above the surface of
the fabric, press the Shot of Steam button
down firmly and release it during ironing.
An intense burst of steam penetrates
deep into the fabric.
NOTE: For optimal steam quality,
wait an interval of at least 4
seconds between presses of the
Shot of Steam button.
Vertical Steam Shot
The Vertical Steam Shot allows you to
use the iron for vertical applications. This
is especially useful for getting wrinkles
out of hanging garments, curtains, wall
hanging etc.
Hold the iron vertically, in front, a slight
distance from the item to be steamed
and press the Shot of Steam button.
CAUTION: Never use
the vertical steam shot
while clothes are on the
body or direct the steam
towards people.
Dry Ironing
Turn the steam selector to the
MIN position.
This shuts off the steam flow should there
be any water in the tank.
Select the required setting on
the temperature dial for the fabric
being ironed.
Once the temperature has been
reached, the heat indicator light will
turn off and the iron is ready for use.
Using the Fine Mist Spray
The fine mist spray can be used to
dampen difficult fabrics, dry areas,
woollen items and accidental creases.
Firmly press the spray button (located on
the handle of the iron) to produce a fine
spray of water ahead of the iron.
The spray can also be used with delicate
fabrics (synthetic) which are ironed at
low temperatures and therefore cannot
be steam ironed.
Loading ...
Loading ...