Loading ...
Loading ...
Loading ...
1. Clean the surface of the hood every week with
mild soap or detergent. Avoid solvents, acid, alkali,
scouring pads or power that could irreparably
damage the stainless steel surface.
2. The grease filters may be washed using mild soap,
detergent or degreasing agents.
3. The filters can be washed in a dishwasher.
4. The charcoal filters cannot be cleaned and must
be generally replaced after 6 months of use.
1. The range hood should be mounted at a distance of 24" (600mm)
from an electric or induction cooktop, and 30" (762mm) above a
gas cooktop for safety and optimum performance (see pic 1). If
the instructions for installation of the gas cooktop specify a greater
distance, this has to be taken into account. The exhaust air must
not be discharged into a flue which is used for exhausting fumes
from other appliances burning gas or other fuels.
2. To install onto the wall, drill 2 holes of Φ8mm in a sturdy wall 3.54"
(90mm) on either side of centre point of range hood. And mount
the bracket on the wall in an appropriate place (see pic 2).
3. Insert expanding screws into the holes (see pic 2).
4. Fix drilling template on the wall.
5. Add the duct (alternative part) and connect it to the kitchen outlet
vent with screws (see pic 3).
6.Take out the inner chimney with outer chimney together from the
package. Pick out one of the brackets from the accesories. Using
two screws M4X8 to lock the bracket on the outer chimney top
(see pic 6 ).
7. Put outer chimney and inner chimney together on the main body
(see pic 4). Pull out the inner chimney and fix the inner chimney to
the bracket by screws. Then insert the outer chimney, the outer
chimney should be fixed on the main body by screws (see pic 5).
8. Ensure that the wall the hood is to be installed on is sufficiently
sturdy to carry the weight of the hood. It should be mounted level
for best performance.
9. Do not connect to a common vent with any other appliances such
as a gas heater, water heater, washer/dryer,etc.
10. The duct should not be bent more then 120° from the one way
valve outlet in the kitchen vent.
11.Check to make sure that the electrical cord is not in contact with
sharp edges of the appliance.
12.Be sure that the plug is accessible after installation.
Loading ...
Loading ...
Loading ...