Loading ...
Loading ...
Loading ...
E7
Heading30" Flush Mount Installation Instructions
3. Place the drawer adjacent to the wall or cabinet
opening. Plug the power supply cord into the electrical
outlet.
4. Carefully guide the drawer into the prepared opening.
Avoid contact with the sides of the cutout opening and
also pinching the cord between the oven and the wall.
5. Slide the drawer all the way back until the mounting
anges touch the cleats mounted in the cabinet
opening.
6. Open the drawer. Using the 4 holes on the drawer as a
template, pre drill the cabinet using a 1/16” (1.57 mm)
bit. See Figure 4.
Figure 3A
Figure 4
Figure 3B
2. Install deector as shown in Figure 3A.
7. Secure the drawer with the 4 screws supplied.
Mounting
flange
Figure 2B
Figure 2C
A. 28
7
/16" (722.3 mm) mounting
cleat opening width
B. 30
5
/16" (769.92 mm) minimum
30
5
/8" (777.87 mm) maximum
ush opening width
C.
3
/4" (19.05 mm) shelf
Front view
No oven
C
B
A
Suggested electrical
outlet location
Anti-Tip block
3
/4" (19.05 mm)
shelf
Side view
1
3
/4" (44.45 mm)
front face of shelf
Front face of cabinet
16
7
/8"
(428.62 mm)
flush opening
height
Move oven location
downward for extended
countertops for better
viewing angle.
Anti-Tip
block
Shelf detail showing the deflector shield installed.
Shelf detail showing the deflector vent during installation.
Position deflector vent and mark holes. Pre drill using a
1
/16" (1.57 mm)
bit before mounting.
Loading ...
Loading ...
Loading ...