Loading ...
Loading ...
Loading ...
5
LOCATION OF PARTS
Handle
Half Shelf (Total 1)
Door
Digital Control Panel
Levelling Legs
Security Lock
Interior Light
Full Shelf (Total 3)
INSTALLATION INSTRUCTIONS
BEFORE USING YOUR APPLIANCE
Remove the exterior and interior packing.
CAUTION: After unpacking and before connecting the appliance to the power source, you MUST
allow this appliance to stand upright for at least 2 hours to allow the lubricant and refrigerant to
drain back into the compressor and stabilize. Failure to do so may adversely affect performance
and the lifetime of this unit.
Clean the interior surface with lukewarm water using a soft cloth.
Install the handle on the door. (See page 7.)
INSTALLATION OF YOUR APPLIANCE
Your appliance is designed to be built-in (fully recessed). When installing the unit, leave at least 3/16”
at both sides, 1/16” at the top and 2” at the rear. Be sure that airflow under the appliance is not blocked.
If installing your appliance inside a cabinet where the front door may be blocked, call our technical
support department at 718-893-3900 ext. 597 for proper cutout and clearance dimensions.
WARNING: Do not store or install the appliance outdoors.
CAUTION: This appliance is designed for storing and cooling beverages and drinks. Do not store
perishable food, medicine or other medical products.
Place your Beverage Merchandiser on a floor that is strong enough to support it when it is fully loaded.
To level the unit, adjust the front leveling legs.
NOTE: It is recommended that you do not install the appliance near an oven, radiator or other heating
source. Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Don’t install in a location where the temperature will fall below 60°F (16°C). For best
performance, do not install the appliance behind a cabinet door or block the base grille.
Loading ...
Loading ...
Loading ...