Loading ...
Loading ...
Loading ...
33
EN
WARNINGS
36
USER INSTRUCTIONS
EN
EN
32
USER INSTRUCTION
6.4
Fig. 6-04
Fig. 6-05
6-05 6-04
6-04
6-05
6-05
5.4 Cleaning the filter unit
• Periodically inspect the filter unit (ref. A fig. 5-04) and, if necessary, clean it
under running water (at room temperature), using a stiff brush. To remove
the filter, grip the tabs, turn anticlockwise and lift upwards;
• push the centre filter (ref. A fig. 5-05) from the underside to remove it from
the micro-filter;
• separate the two parts which make up the plastic centre filter by pressing
the body of the filter in the zone shown by the arrows (ref. B fig. 5-05);
• remove the centre filter by lifting it upwards.
• after cleaning, remount the filter unit, joining the two parts comprising the
centre filter by pushing slightly until they click into place; insert the centre
filter into the micro-filter (see fig. 5-05). Reposition the filter unit (ref. A fig.
5-04) into its seat, turning it clockwise until it locks.
B B
A
Fig. 5-04
Fig. 5-05
EN
33
USER INSTRUCTION
6.5
Fig. 6-06
6-06
5.5 General warnings and recommendations
for correct maintenance
• Clean the filters under running water (at room temperature) using a stiff
brush.
• When removing the filter, take care that there are no food residues on
it. If any residues fall into the washing pit (ref. A fig. 5-06), they might block
hydraulic components or foul the spray arm nozzles.
• It is essential to thoroughly clean the filters according to the above in-
structions: the dishwasher cannot function if the filters are clogged.
• Carefully replace the filters in their seats, to avoid damaging the wash
pump.
A
Prolonged disuse
• Run the soak program twice in succession.
• Unplug the power cord from the socket.
• Leave the door slightly open in order to prevent the formation of unpleas-
ant odors inside the washing tank.
• Fill the rinse-aid dispenser.
• Shut off the water supply tap.
Fig. 5-06
CLEANING THE FILTER UNIT
•
The central filter should be cleaned regularly. To remove it, pull the
spray arm assembly upwards.
• Turn the microfilter M anticlockwise to release and extract it, then lift
the stainless steel filter F.
• Push the central filter H from below to extract it from the micro-filter.
• Separate the two parts of the plastic filter by pressing the body of
the filter in the zone shown by the arrows.
• Remove the central filter by lifting it.
Loading ...
Loading ...
Loading ...