Loading ...
Loading ...
Loading ...
Black plate (232,1)
北米Model "A8150BE-B" EDITED: 2009/ 10/ 2
7-12 Starting and operating
feature programming can be adjusted
using the following procedure.
1. Open the driver’s door (the driver’s
door must remain opened throughout the
entire process).
2. Insert the key into the vehicle’s ignition
switch and turn to the “ON” position.
3. Locate the small black programming
button behind the fuse box cover, on the
driver’s side left unde r the dashboard
panel.
4. Press and hold the black programming
button for 10 to 15 seconds. The horn will
honk and the turn signal lights will flash
three times to indicate that the system has
entered programming mode. At this point
you can proceed to either step 5 or step 6.
5. To program a remote transmitter:
press and release the “
” button on each
transmitter. The horn will honk and the
turn signal lights will flash one time to
indicate a successf ul transmitter learn
each time the “
” button is pressed. You
can program up to eight transmitters.
6. To toggle the Horn Confirmation chirps
ON/OFF: press and release the brake to
toggle the feature. The horn will chirp and
the turn signal lights will flash one time to
indicate Confirmation Horn Chirps are
“OFF”. The horn will honk and the turn
signal lights will flash 2 times to indicate
Confirmation Horn Chirps are “ON”.
Pressing the brake pedal repeatedly will
toggle the feature ON or OFF each time.
7. To exit the remote tra nsmitter and
feature programming mode, turn the igni-
tion switch to the “LOCK” position, remove
the key from the ignition switch and test
operation of the remote transmitter(s) and
horn confirmation feature.
& System maintenance
! Changing the remote control bat-
teries
CAUTION
. Do not let dust, oil or water get on
or i n the remote engine start
transmitter when replacing the
battery.
. Be careful not to damage the
printed circuit board in the re-
mote engine start transmitter
when replacing the battery.
. Be careful not to allow children to
touch the battery and any re-
moved parts; children could
swallow them.
. There is a danger of explosion if
an incorrect replacement battery
is used. Replace only with the
same or equivalent type of bat-
tery.
. Batteries should not be exposed
to excessive heat such as sun-
shine, fire or the like.
The two 3-volt lithium batteries (model
CR-1220) supplied in your remote control
should last approximately 3 years, de-
pending on usage. When the batteries
begin to we aken, you will notice a
decrease in range (distance from t he
vehicle that your remote control operates).
Follow the instructions below to change
the remote control batteries.
Loading ...
Loading ...
Loading ...