Loading ...
Loading ...
Loading ...
1 Disconnect the shaver from the mains, remove it from the Jet Clean
System (specic types only) or remove it from the charging stand
(specic types only).
2 Let the shaver operate until it stops.
3 Undo the screws in the back of the shaver and in the hair chamber.
4 Remove the front panel and the back panel.
5 Bend the 6 hooks aside and take out the power unit.
Be careful, the hooks are sharp.
6 Remove the battery.
Be careful, the battery strips are sharp.
Do not put the shaver back into the plugged-in Jet Clean System
(specic types only) or charging stand (specic types only) after you have
removed the rechargeable battery.
Do not connect the shaver to the mains again after you have removed
the rechargeable battery.
Guarantee and support
If you need information or support, please visit www.philips.com/
support or read the worldwide guarantee leaet.
Guarantee restrictions
The shaving heads (cutters and guards) are not covered by the terms of
the international guarantee because they are subject to wear.
Troubleshooting
This chapter summarises the most common problems you could encounter
with the appliance. If you are unable to solve the problem with the
information below, visit www.philips.com/support for a list of frequently
asked questions or contact the Consumer Care Centre in your country.
Problem Possible cause Solution
The shaver does
not shave as well
as it used to.
The Jet Clean System (PT927CC/
PT923CC only) has not cleaned the
shaver properly because the cleaning
uid in the cleaning chamber is soiled
or the cleaning uid level is too low.
Clean the shaver thoroughly before you
continue shaving. If necessary, clean and
rell the cleaning chamber (see chapter
‘Cleaning and maintenance’).
The shaving heads are damaged or
worn.
Replace the shaving heads (see chapter
‘Replacement’).
Long hairs obstruct the shaving heads. Clean the shaving heads one by one (see
section ‘Cleaning the shaving unit with the
cleaning brush’ in chapter ‘Cleaning and
maintenance’).
ENGLISH20
Loading ...
Loading ...
Loading ...