Loading ...
Loading ...
Loading ...
11
3.7
START/PAUSE BUTTON
When the program is completed
the 3 zeros will flash.
Incorrect Option Selection
If an option which is not compatible
with the set wash program is
selected, the display will show
“ ” and flashing with 3
consecutive short beeps
End Of Program
In the event of operating problems,
some alarm codes can be
displayed, for example (see
“Troubleshooting” and
“Troubleshooting fault displays” on
page 26, 27, 28).
Alarm Codes
3.8
DELAY END OPTION
BUTTON
(On model SWT6541,
SWT6541M, SWT6541Q, SWT6541T
)
Before you start the program, this
option makes it possible to delay the
end of the washing program by 2, 4,
6, 8, 10 or 12 hours, by pressing
Delay End button to choose the end
time as your wish. This option must
be selected after choosing the wash
program, and before pressing the
“Start/Pause” button. If after having
set the Delay-End option (and
pressed “Start/Pause” button) and
you wish the cancel or modify it,
follow the below steps:
set the washing machine to
PAUSE by press “Start/Pause”
button;
-
deselect the Delay-End option,
changing the status;
-
press the “Start/Pause” to start
the program.
-
3.6
DISPLAY
The display shows the following
information:
Machine In Pause Mode
You can tell when your washing
machine is in pause mode. The
time remaining and “ ” will be
flashing.
Estimated time of the
selected program
After selecting a program, the
estimate time is displayed in hours
and minutes (for example 1.04).
The estimate time is calculated
automatically on the basis of the
maximum recommended load for
each type of fabric. After the
program has started, the time
remaining is updated every minute.
If the lid has been opened any
time during operation of the
machine, the Start/Pause
button has to be pressed when
the lid is closed to continue
operation.
To start the selected program,
press the “Start/Pause” button.
If you have started your wash and
you wish to stop it for some reason,
press the “Start/Pause” button to
enter PAUSE mode. To restart the
program from the point at which it
was interrupted, press the
“Start/Pause” again.
Loading ...
Loading ...
Loading ...