Loading ...
Loading ...
Loading ...
52 En
Configure the system settings of the unit using the front
panel controls.
1 Press A (power) to turn off the unit.
2
While holding down RETURN, press
A (power).
3 Rotate SELECT/ENTER to select an item.
4 Press SELECT/ENTER to select a setting.
5 Press A (power) to set the unit to turn off and
turn it on again.
The new settings take effect.
ADVANCED SETUP menu items
Checking the firmware version
(VERSION)
Check the version of firmware currently installed on the
unit.
Note
• You can also check the firmware version in “Update (Network
Update)” (p. 50) in the “Setup” menu.
• It may take a while until the firmware version is displayed.
Changing the speaker impedance
setting (SP IMP.)
Change the unit’s speaker impedance settings depending
on the impedance of the speakers connected.
Settings
Selecting the remote control ID
(REMOTE ID)
Change the unit’s remote control ID so that it matches the
remote control’s ID.
Select “ID1” normally. Select “AUTO” only when you
use the remote control supplied with some Yamaha player.
Settings
ID1 (Default), AUTO
Configuring the system settings (ADVANCED SETUP menu)
Item Function Page
VERSION
Checks the version of firmware
currently installed on the unit.
52
SP IMP.
Changes the speaker impedance
setting.
52
REMOTE ID Selects the unit’s remote control ID. 52
TU
(Asia and General models only)
Sets tuner frequency step.
53
INIT Restores the default settings. 53
UPDATE Updates the firmware. 53
VOLUME
PURE DIRECT
RETURN
CONNECT
PUSH - ENTER
TUNINGPRESET
BAND
MEMORY CLEAR
BASSINPUT
5V
1A
BALANCE
LR
TREBLE
LOUDNESS
FLAT
-30dB
DIMMER MODE
DISPLAY
SELECT
PHONES
YPAO MIC
SPEAKERS USB
AB
A (power)
SELECT/ENTER
RETURN
DISPLAY
4 MIN
Select this option when you connect speakers with
an impedance of 4 ohms to less than 8 ohms to the
unit.
8 MIN
(Default)
Select this option when you connect speakers with
an impedance of 8 ohms or more to the unit.
VERSION••xx.xx
SP IMP.••8¬MIN
REMOTE ID••ID1
Loading ...
Loading ...
Loading ...