Loading ...
Loading ...
Loading ...
11
4
4.3
4.4
4.2
www.fhiaba.com ∙ [email protected] ∙ Tel +39 (0)434 420160 ∙ Fax +39 (0)434 420161
An integrated control system provides information through lighted sig-
nals or text messages visualized on the display.
The information signal is always visualized with a xed text message,
while a malfunction signal is visualized with blinking text.
The sound signal that accompanies some malfunction signals can be de-
activated by pressing the Alarm button on the main control panel.
The list of malfunction signals is located at the back of this manual.
Appliance switching on and off
Each model has been carefully tested before leaving the factory and
is adjusted in such a way to ensure high performance and low con-
sumption. Usually, it is not necessary to modify the settings.
Nevertheless, according to special needs, it is possible to modify the
set temperatures as follows:
Refrigeration Compartment
Fresco Compartment
Freezer Compartment
(TriMode)
From +2°C to +8°C (from 35.6°F to 46.4°F), the recommended preset
temperature is +5°C (41°F).
To adjust the temperature use the Up/Down buttons
.
Upon touching these buttons the newly set temperature will appear in
the display. To modify this temperature, use the buttons until reaching
the desired temperature.
From -2°C to +2°C (from 28.4°F to 35.6°F), the recommended preset
temperature is 0°C (32°F).
To adjust the temperature use the Up/Down buttons
.
Upon touching these buttons the newly set temperature will appear in
the display. To modify this temperature, use the buttons until reaching
the desired temperature.
From -15°C to -22°C (from 5°F to -7.6°F), the recommended tempera-
ture is preset at -18° (0°F).
To adjust the temperature use the Up/Down buttons
.
Upon touching these buttons the newly set temperature will appear in
the display. To modify this temperature, use the buttons until reaching
the desired temperature.
In case the compartment is used as refrigerator or Fresco compart-
ment (TriMode function) the recommended and preset temperatures
will correspond to those indicated for the respective compartments.
The temperature shown can vary slightly in re-
spect to the set temperature following frequent
openings of the doors or insertion of room tem-
perature foods or large quantities of foods.
6 to 12 hours are necessary to reach the select-
ed temperature.
Ice Maker Activation
The Ice Maker button located on the main control panel permits
activation of the automatic icemaker.
The button is illuminated when the icemaker is functioning.
A prewash of the hydraulic circuit should be performed before acti-
vating the Ice Maker for the rst time. To do this touch at the same time
buttons Enter and Ice Maker .
After a few minutes the Ice Maker can be activated.
Information and malfunction messages on the display
How to adjust the temperature for different requirements
Do not activate the Ice Maker unless the appli-
ance is connected to the water mains.
Loading ...
Loading ...
Loading ...