Loading ...
Loading ...
Loading ...
ActionPossible causesProblem
Check that the salt compartment lid is
properly tightened. Otherwise call the
Customer Care Center.
The water softener is leaking salt.Spots or films on the dishes.
See the chapter Settings.Incorrect water softener setting.
See the chapter Settings.Incorrect rinse aid dosage setting.
Top up with salt. See the chapter Before
washing for the first time.
Salt compartment empty.
Inactivate the setting TAB (3-in-1/all-in-
one detergent) and top up with salt and
rinse aid.
3-in-1/all-in-one detergent is used and
the setting TAB (3-in-1/all-in-one deter-
gent) is activated.
Wash crystal at a low temperature and
with a conservative amount of detergent.
Contact the detergent manufacturer.
Too high temperature and/or too much
detergent can cause etching on crystal.
Unfortunately, this cannot be repaired,
only prevented.
Reduce the amount. See the sections
Before washing for the first time and
Settings. If you have very soft water, you
may want to dilute the rinse aid 50:50
with water.
Rinse aid dosage setting too high.The dishes have a sticky white/blue film.
Use a detergent with a bleaching agent.Lipstick and tea can be difficult to wash
off.
Spots left after washing.
The detergent compartment must be dry
when adding detergent.
The detergent compartment was damp
when adding detergent.
Detergent residue in the detergent com-
partment after dishwashing.
Check that the dishes are placed secure-
ly. Spin the spray arms to make sure
they can rotate.
The dishes are not correctly placed or
the spray arms are not rotating.
Rattling sound when dishwashing.
See the chapter Using the dishwasher.The ION setting is activated.Sound from a fan is heard even when
no dishwashing program is running.
If you want the dishwashing program to
continue, press any button and close the
door within five seconds.
The dishwasher door has been opened
while a program is in progress.
"STR" is shown on the display.
If you want to cancel the dishwashing
program, press and hold the main power
switch until the display turns off.
Clean the coarse and fine filters.The filters are blocked.Water remains in the dishwasher above
the filters.
Clean the drain pump. See the chapter
Care and maintenance instructions.
Debris in the drain pump.
Check that the hose is free from kinks
and sharp bends.
Kink in drain hose.
Loosen the drain hose from where it
terminates. Check that no debris has
clogged the hose. Is the cone-shaped
part of the drain boot cut to the maxi-
mum size of the fitting where it attaches?
Blocked drain hose.
18
Loading ...
Loading ...
Loading ...