Loading ...
Loading ...
Loading ...
The Timer 29
The Timer
5 Set the timer to the hour and the minutes you want
to start recording.
1 Turn the jog dial to set the hour and press
ENTER•MEM.
2 Turn the jog dial to set the minutes and press
ENTER•MEM.
6 Set the timer to the hour and the minutes you want
to stop recording. (Do as step 5.)
7 Turn the jog dial to set the volume you want, and
press ENTER•MEM.
8 Press STANDBY.
The power goes off and the player enters the
standby mode. The
indication and the recording
side of the tape (upper side N or reverse side n)
appear in the display. To change the recording
side, press STANDBY again.
At the preset time, the power will go on and the
recording will start. Then the power will go off at
the preset time, and the player will enter the
standby mode again.
To check/change the recording timer settings
Press TIMER, then ENTER•MEM. Each time you press
ENTER•MEM, a stored setting is displayed in the set
order. To change the setting, display the setting you
want to change and re-enter it.
To use the player before a timer-recording starts
If you turn on the player, you can use it as usual ( in
case of the radio, if you listen to the station which is
different from the one you tuned in step 1 on page 28,
you will record that station at the preset time.) Turn
off the player before the preset time.
To stop timer-recording
Turn off the power.
Tips
• To exit the standby
mode, press STANDBY
twice to make the
indication disappear.
• The preset settings
remain until you reset
them.
• When you select both
sides recording, the
recording will stop
after the both sides
recording finishes so
that accidental
recording will not be
made.
Tip
If you made a mistake,
press CANCEL. The
setting entered last will
be cleared. Re-enter it.
Loading ...
Loading ...
Loading ...