Loading ...
Loading ...
Loading ...
Page 6 • JL Audio, Inc., 2018 Continued on Next Page
STEP 24
Slide a 5/16” Rubber Sealing Washer, the
5/16” Oversized Flat Washer, a 5/16” Split Lock
Washer, and the 5/16 - 18 Hex Nut over the
empty 5/16 - 18 x 1-1/4” Square Neck Carriage
Bolt, and fully tighten.
Repeat the process for the other 5/16 - 18 x
1-1/4” Square Neck Carriage Bolt.
STEP 23
Slide a 5/16” Oversized Flat Washer and a 5/16
- 18 Hex Nut over each of the 5/16 - 18 x 1-1/4”
Square Neck Carriage Bolts, and fully tighten.
This allows the enclosure to seat properly over
the Mounting Bracket.
Remove the 5/16 - 18 Hex Nut and 5/16”
Oversized Flat Washer from only one of the
5/16 - 18 x 1-1/4” Square Neck Carriage Bolts.
STEP 22
Place the enclosure onto the wheel well,
allowing the two 5/16 - 18 x 1-1/4” Square Neck
Carriage Bolts to pass through the holes in the
bottom of the enclosure.
STEP 21
Remove the eight subwoofer mounting screws.
Disconnect the subwoofer, and remove it from
the enclosure. Remove the batting from the
enclosure.
SB-J-JL4DDRV/10TW1 & SB-J-JL4DPAS/10TW1 INSTR_SKU# 011510
STEP 20
Remove the trim panel from the enclosure.
STEP 19
Remove the four M6 x 45mm Socket
Flanged Button Screws from the front of the
Stealthbox®.
STEP 18
Pass the 5/16 - 18 x 1-1/4” Square Neck Carriage
Bolts through the cuts in the carpet, as shown.
STEP 17
Push the carpet back down to the wheel well.
Locate the locations of the two 5/16 - 18 x
1-1/4” Square Neck Carriage Bolts. Cut a small
“X” in the carpet to allow the hardware to pass
through.
Loading ...