Loading ...
Loading ...
Loading ...
3
• The room for installing the appliance must be at least 1 cubic metre per 8 grams of refrigerant. The refrigerant quantity
contained in this appliance is listed above in grams; it is also noted on the Rating Plate of the appliance.
* Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
It is hazardous for anyone other than an Authorised Service Person to carry out servicing or repairs to this appliance. In
Queensland the authorized person must hold a Gas Work Authorisation for hydrocarbon refrigerants, before carrying out
servicing or repairs which involve the removal of covers.
–WARNING: Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction.
–WARNING: Do not use mechanical devices or other means to accelerate the defrosting process, other than those
recommended by the manufacturer.
–WARNING: Do not damage the refrigerant circuit.
–WARNING: Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of
the type recommended by the manufacturer.
The environment and personal safety must be considered when disposing of this appliance. Please ensure the appliance is taken to
a recycle center for safe recycling. DO NOT dispose of the appliance in land fill as the insulation and refrigerant gas contained in
these appliances are flammable.
INSTALLATION INSTRUCTIONS
Before Using the Refrigerator
Remove the exterior and interior packing.
Before connecting the refrigerator to a power source, let the unit stand upright for approximately 4 hours to mitigate the
possibility of a malfunction in the cooling system from improper handling during transportation.
Clean the interior surface with lukewarm water using a soft cloth. (Refer to the cleaning instruction on page 4)
Installing the Refrigerator
This appliance is designed to be free standing only, and should not be recessed or built-in.
Place the refrigerator on a leveled/even floor surface that is strong enough to support the weight of the refrigerator when it is
fully loaded to prevent vibrations and allow water to properly drain.
The leveling feet should only be used in forward and backward motions and never side to side.
Allow at least 5cm of space between the back and sides of the refrigerator to allow proper air ventilation. Adjust the
two front feet to keep the refrigerator leveled or elevated.
Situate the refrigerator away from direct sunlight and sources of direct heat (stove, heater, radiator, etc.). Direct sunlight may
also affect the acrylic coating and heat sources may cause an increase electrical consumption. Ambient temperature below
50°F or above 85°F will hinder the performance of this appliance.
This unit is not designed for outside installation.
Avoid situating the refrigerator in moist OR pest infestation areas.
Plug the refrigerator into dedicated, properly installed-grounded wall outlet. Do not under any circumstances cut or remove the
third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a
certified electrician or an authorized service center.
ENERGY SAVING TIPS
Allow hot foods to cool to room temperature before placing in the refrigerator. Overloading the refrigerator forces the
compressor to work harder. Foods that freeze too slowly may lose quality, or spoil.
Do not adjust the temperatures colder than necessary. Refer to page 4 for temperature instructions.
Be sure to wrap foods properly, and wipe containers dry before placing them in the refrigerator. This cuts down on frost build-
up inside the refrigerator.
Organize and label food to reduce door openings and extended searches. Remove as many items as needed at one time, and
close the door as soon as possible.
Refrain from leaving the door/s open for a long time to conserve energy.
Loading ...
Loading ...
Loading ...