Loading ...
Loading ...
Loading ...
11
20V Max Lithium Cordless Blower EN
OPERATION
INTENDED USE:
The blower is intended for residential use only. Use
the blower outdoors to move yard debris as needed.
ASSEMBLY AND OPERATION
ACTION FIGURE
ASSEMBLY
Assembling & disassembling the
Blower Tube
See Fig.
A, B
Installing & removing the battery pack
NOTE: Press the battery release button
to release battery pack from your tool.
After recharging, insert the battery pack
into tool’s battery port. A simple push
and slight pressure will be sufficient.
See Fig.
C, D
Charging the battery pack
Your battery pack is UNCHARGED, you
must charge before use.
More details can be found in charger’s
manual.
WARNING! The charger and
battery pack are specially
designed to work together, so do
not attempt to use any other devices.
Never insert or allow metallic objects
into your charger or battery pack
connections because of an electrical
failure and hazard will occur.
See Fig.
E1, E2, E3
OPERATION
Starting & Stopping
WARNING!
The tool runs for a
few seconds after it has been
switched off.
Let the motor come to a complete
standstill before setting the tool down.
See Fig. F
Adjusting the blowing speed with
2-speed switch
USER TIPS
- Hold the blow tube approximately
8” above the ground when operating
the tool.
Use a sweeping motion from side
to side. Advance slowly keeping the
accumulated debris/leaves in front of
you.
- After blowing the debris/leaves into a
pile, it is easy to dispose of the pile.
Caution!
- Do not blow hard objects such as
nails, bolts, or rocks.
- Do not operate the blower near
bystanders or pets.
- Use extra care when cleaning debris
from stairs or other tight areas.
- Wear safety goggles or other suitable
eye protection, long pants, and shoes.
See Fig. G
To store your cordless blower
NOTE: You can store your cordless
blower by hanging it on the wall with
your own wall hanging support at the
back of the blower.
See Fig. H
FOR BATTERY TOOLS
The ambient temperature range for the use and
storage of tool and battery is 0
o
C-45
o
C.
The recommended ambient temperature range for
the charging system during charging is 0
o
C-40
o
C.
CLEANING THE TOOL
Clean the tool regularly.
Warning! Keep your product dry. Under
no circumstances spray with water.
- To clean the tool, use only mild soap and a
damp cloth.
- Do not use any type of detergent, cleaner
or solvent which may contain chemicals
that could seriously damage the plastic.
- Self lubricating bearings are used in
your product, therefore lubrication is not
required.
Loading ...
Loading ...
Loading ...