Loading ...
Loading ...
Loading ...
11
Selecting the proper location for your washer/dryer improves
performance and minimizes noise and possible washer “walk.”
Your washer/dryer can be installed in a basement, laundry room,
or recessed area. This washer/dryer is not intended for install in
a mobile home or recreational vehicle. See the “Drain System”
section.
Companion appliance location requirements should also be
considered.
IMPORTANT: Do not install or store the washer/dryer where it will
be exposed to the weather. Do not store or operate the washer/dryer
in temperatures at or below 32°F (0°C). Some water can remain
in the washer and can cause damage in low temperatures. Proper
installation is your responsibility.
You will need:
■ A water heater set to deliver 120°F (49°C) water to the washer.
■ A grounded electrical outlet located within 6 ft. (1.8 m) of
where the power cord is attached to the back of the washer.
See “Electrical Requirements.”
■ Hot and cold water faucets located within 4 ft. (1.2 m)
of the hot and cold water fill valves, and water pressure
of 20–100 psi (137.9–689.6 kPa).
■ A level floor with a maximum slope of 1" (25 mm) under entire
washer/dryer. Installing the washer/dryer on soft floor surfaces,
such as carpets or surfaces with foam backing,
is not recommended.
■ A sturdy and solid floor to support the washer/dryer with a total
weight (water and load) of 450 lbs (204 kg).
■ A floor drain under the bulkhead. Prefabricated bulkheads with
electrical outlets, water inlet lines, and drain facilities should be
used only where local codes permit.
Stacked Washer/Electric Dryer Location
STACKED WASHER/ELECTRIC DRYER INSTALLATION
REQUIREMENTS
Stacked washer/electric dryer installation clearances
■ The location must be large enough to allow the washer and
dryer doors to be fully opened.
■ Additional spacing should be considered for ease of installation
and servicing. The doors open more than 180°. The washer
door is not reversible.
■ Additional clearances might be required for wall, door, and floor
moldings.
■ Additional spacing of 1" (25 mm) on all sides of the washer/
dryer is recommended to reduce noise transfer, and improve
spin-up performance of washer.
■ Companion appliance spacing should also be considered.
Recessed Area and Closet Installation Instructions
This washer/dryer may be installed in a recessed area or closet.
For recessed area and closet installations, minimum clearances
can be found on the warning label on the rear of the dryer.
The installation spacing is in inches and is the minimum allowable.
Additional spacing should be considered for ease of installation,
servicing, and compliance with local codes and ordinances.
NOTE: The dryer must be exhausted outdoors.
Loading ...
Loading ...
Loading ...