Loading ...
Loading ...
Loading ...
Installation
*INSTALLATION*
45
Installation
Preparing the countertop
Create the countertop cut-out as
shown in the cooktop diagram. Re-
member to maintain the minimum
safety distances (see “Installation–
Safety distances”).
Seal any cut surfaces on the wooden
countertop with a special varnish, sili-
cone rubber, or resin to prevent the
wood from swelling as a result of
moisture. The sealant must be tem-
perature-resistant.
Ensure that the sealant does not get
on the top surface of the countertop.
The sealing strip ensures that the
cooktop will sit securely in the cut-out
without slipping. Any gap between the
trim and countertop will become
smaller over time.
Installing the cooktop
Feed the appliance power cord down
through the counter cut-out.
Place the cooktop centrally in the
cut-out. When doing this make sure
that the seal of the appliance sits
flush with the countertop on all sides.
This is important to ensure an effec-
tive seal all round.
If during installation the seal around
the frame does not sit flush with the
countertop in the corners, the corner
radius, maximum 3/16" (≤R4/ 4mm),
can be carefully filed down to fit.
Do not use any additional sealant
(e.g. silicone).
Connect the cooktop to the electrical
power supply (see “Installation–
Electrical connection”).
Connect the cooktop to the gas sup-
ply (see “Installation–Gas connec-
tion”).
Loading ...
Loading ...
Loading ...