Loading ...
Loading ...
Loading ...
9
English
EN
Prepare the remote control
Note
• Risk of explosion! Keep batteries away from heat,
sunshine or re. Never discard batteries in re.
• Danger of explosion if the battery is incorrectly
replaced. Replace only with the same or equivalent
type.
1 Open the battery compartment.
2 Insert one AAA battery with correct
polarity (+/-) as indicated.
3 Close the battery compartment.
Note
• If you are not going to use the remote control for a
long time, remove the battery.
• Batteries contain chemical substances, so they should
be disposed of properly.
Install radio stations
automatically
When you connect power and no radio
stations are stored, the unit automatically begins
to store radio stations.
1 Connect the unit to power supply.
» [AUTO FM INSTALL - PRESS PLAY--
STOP CANCEL] (auto FM install
- press PLAY to start - press STOP to
cancel) is displayed.
2 Press to start installation.
» [AUTO] (auto) is displayed.
» The unit automatically stores radio
stations with sufcient signal strength.
» When all the available radio stations
are stored, the rst preset radio station
is broadcast automatically.
Set clock
1 In standby mode, hold CLOCK for more
than two seconds to activate clock setting.
» 'CLOCK SET' is displayed. Then, the 12
hour or 24 hour format is displayed.
2 Press / repeatedly to select 12 hour
or 24 hour format.
3 Press CLOCK to conrm.
» The hour digits are displayed and begin
to blink.
4 Press / repeatedly to set the hour,
then press CLOCK to conrm.
» The minute digits are displayed and
begin to blink.
5 Press / repeatedly to set the minute,
then press CLOCK to conrm the set
clock.
Tip
• During setting, you can press to exit clock setting
without saving the earlier operation.
• During setting, if no action is taken within 90 seconds,
the device exits clock setting automatically without
saving the earlier operation.
• During play or in ECO Power standby mode, you press
CLOCK to view the set clock.
Loading ...
Loading ...
Loading ...