Loading ...
Loading ...
Loading ...
5
4. Introduction
O
ur feet play a very important role throughout our lives as they constantly bear our full weight. Each foot has
2
6 bones, 22 joints, and 107 ligaments, and they all need care. Choosing a Beurer Foot Spa is a step in the
r
ight direction. The gentle vibration massage relaxes tense muscles and after just a few minutes you will feel
m
ore relaxed and stress-free. This effect will be intensified by the spa’s aeration effect.
T
IPS: Add arnica, rosemary, sea salt extracts, lavender or thyme to warm water to bring relief to tired feet.
5. Before First Use
1
. Remove the packaging.
2
. Check the device, power supply and cord for damage.
3
. Place the foot bath on a firm and level surface.
4
. Select a pedicure attachment, place it into the holder between the foot wells, and press firmly.
a.The Brush attachment stimulates reflex zones in the soles of your feet.
b.The Massage Balls attachment soothes your feet.
c.The Callus Remover attachment removes the dead, rough skin of corns and calluses.
5
. If not already attached, attach the Splash Guard by raising the Carrying Handle and then pressing the tabs
in the Splash Guard into the corresponding slots in the lip of the Foot Spa.
6. To Use
1
. Fill the Foot Wells with warm or cold water up to the MAX fill line (1½ in – 2 in, or about 4 - 5 cm). The foot
rest should, however, be completely covered with water.
The foot bath is balanced only when it is filled no further than the fill-level mark. Otherwise, the Foot
Spa may tip over when the carrying handle is used.
2
. Plug the power cord into an electrical outlet. Route the power cord so that it does not pose a trip hazard.
3
. Sit comfortably in a chair and place your feet into the Foot Wells. Never stand up in the Foot Spa.
4
. The device has two massage functions:
•
Function 1: bubble massage, red light and maintaining of water temperature
•
Function 2: activation of vibration massage
4.1. Bubble massage
To activate the bubble massage (function 1), press the Power Button ( ) once to activate the Foot
Spa. Air bubbles will stream out of the Foot Wells and the Red Light will illuminate. These functions
can not be switched on or off separately.
Press the Power Button again to shut the bubble massage function off.
4.2. Vibration massage
While the bubble massage with red light and water temperature control (function 1) is running, you can
switch on the vibration massage. The vibration massage will only function when function 1 is switched
on. It cannot be used separately.
To activate the optional vibration massage (function 2), press the Vibration Button ( ). Press the
Vibration Button again to shut the vibration function off.
5
. To experience additional massage effects, move your feet back and forth over the Massage Rollers in the
Foot Wells. The rollers can be removed if desired by pulling up on them firmly.
6
. Press the Power Button to shut the Foot Spa off.
7
. To empty the water, tip the Foot Spa in the direction of the Drain Spout.
Loading ...
Loading ...
Loading ...