Loading ...
Loading ...
Loading ...
Sanitize the dispenser water tank prior to
installing a full bottle of water for the first time
(see “Cleaning and Sanitizing the Water Tank”).
IMPORTANT: Make sure the dispenser is
unplugged. Before placing the water bottle on
the dispenser, wash hands and wipe the top of
the bottle with a clean cloth. Avoid touching the
part of the bottle that will be in contact with the
water dispenser.
Make sure the water level in the top of the
dispenser is low enough to allow for proper
bottle installation. Failure to do so may cause
the dispenser to overflow.
1. Peel the label from the top cover of the
bottle (if present). Do not remove the
entire bottle cap.
2. Place the bottle on top of the dispenser
as shown, aligning the dispensing valve
probe to the center of the water bottle
cap. Press down until the probe
penetrates the bottle cap, allowing the
bottle to rest on the support collar.
3. IMPORTANT: Press both dispense levers
until water runs from both taps.
4. Plug in the dispenser.
5. Allow 30 minutes for water to reach cold
temperatures.
Contact a local water bottle distributor to
purchase water bottles.
Loading the Dispenser
4
Using the water dispenser.
Bottle Support Collar (WS28X10046)
Separator (WS28X10020)
Cold Water Tank
Cold (Blue) Faucet
Room Temperature (White) Faucet
Dispenser Drip Tray (WS28X10021) and
Grille (WS28X10022)
Base
(Top Cover – WS30X10006)
(Back Side – WS30X10007)
(Bottom Cover – WS30X10008)
(Front Side – WS30X10009)
See the back page of this manual
for ordering instructions.
Features and Parts List
1. Align the front and back pieces of the
base (pieces labeled 1 and 2), with “UP”
pointing up, and snap together. If it does
not go together, make sure “UP” is in the
same direction on both pieces.
2. Place the top cover (piece 3) on top of
pieces 1 and 2 (front and back). Press
down firmly until it snaps into place.
3. Turn the assembly over and place the
bottom cover (piece 4) on top of pieces
1 and 2 (front and back). Press down
firmly until it snaps into place.
4. Turn base over and place the dispenser
on top of the base.
Assembling the Base
UP
UP
NOTE: The top (3) and bottom (4)
pieces can be found in the top and
bottom of the carton packaging foam.
Loading ...
Loading ...
Loading ...