Loading ...
Loading ...
Loading ...
A3/A3Pro
User Manual
©
2016 DJI. All Rights Reserved.
23
The aircraft automatically descends and lands if RTH is triggered when the aircraft ies
within a 65-foot (20-meter) radius of the Home Point.
The aircraft cannot return to home if the LED is slowly blinking yellow or the GPS does
not work.
The aircraft cannot avoid obstacles during Failsafe RTH. Therefore it is important to
set a reasonable Failsafe altitude before each ight. Launch the DJI GO app and enter
“Camera” view and select “MODE” to set the Failsafe altitude.
The aircraft will stop ascending and immediately return to the Home Point if you move
the throttle stick when the aircraft reaches an altitude of 20 m or above during Failsafe.
1 Record Home Point (HP)
Flashing Green
5 Go Home(20m can be set)
Flashing Yellow Rapidly
3 Remote Controller Signal Lost
Flashing Yellow Rapidly
2 Conrm Home Point
Flashing Green
6 Landing after Hovering 15secs
Flashing Yellow Rapidly
4
Signal Lost Lasts 3secs.
Flashing Yellow Rapidly
Height over HP>20m
Elevate to 20m
Height over HP<=20m
20m
Lightbridge 2 not only allows you use the DJI GO app to operate the aircraft, but also
use Intelligent Flight Modes, such as Course Lock, Home Lock, Point of Interest (POI)
and Waypoints, to capture professional shots during ight.
Protection Functions
Return to Home
Return to Home (RTH) brings the aircraft back to the last recorded Home Point. There are three
cases that will trigger the RTH procedure; they are Failsafe RTH, Smart RTH and Low Voltage
RTH with a LiPo battery.
Failsafe RTH
Failsafe RTH is activated automatically if the remote controller signal (including video relay signal if
DJI Lightbridge 2 used) is lost for more than 3 seconds, provided that the Home Point has been
successfully recorded and the compass is working normally. The RTH process may be interrupted
and the operator can regain control over the aircraft if a remote controller signal is resumed.
Loading ...
Loading ...
Loading ...