Loading ...
Loading ...
Loading ...
9
Turning On The Heated Throw
Ensure the heated throw Power/Heat
Setting button is in the ‘OFF’ position
and not pressed.
Plug the power cord into a 230V or
240V power outlet and switch the
power on.
Press the Power/Heat Setting button
once to turn the heated throw ‘ON’.
Adjusting The Heat
Temperature
The three heat settings allow you to
choose the right balance of heat
depending on your personal comfort.
Adjust the heat temperature by
pressing the Power/Heat Setting
button until the desired indicator light
illuminates:
LOW Heat Setting
Press the Power/Heat Setting button
once and the Orange coloured LED
indicator will illuminate.
MEDIUM Heat Setting
Press the Power/Heat Setting button
twice and the Blue coloured LED
indicator will illuminate.
HIGH Heat Setting
Press the Power/Heat Setting button
three times and the Green coloured
LED indicator will illuminate.
NOTE: The heated throw will take
40 minutes to reach the desired
setting temperature, however
you will start feeling warm after
15-20 minutes.
Auto-Off Protection
For added safety, the heated throw is
designed with auto-off protection.
After three hours the heated throw
will automatically turn off and the Red
coloured auto off LED indicator will
illuminate and "flash".
To stop the auto-off LED indicator from
"flashing" and to continue using the
heated throw, press the Power/Heat
setting button once to turn the throw
‘ON’ again.
Set the heat temperature according
to your heat preference. The throw is
now ready for another three hours of
use.
Turning Off The Heated Throw
Press the Power/Heat Setting button
until none of the heat setting indicator
lights are illuminated. The heated
throw is now in the ‘OFF’ position.
Switch off at the power supply and
unplug the power cord from the
power outlet.
NOTE: For added safety, after
three hours the heated throw
automatically switches off.
NOTE: Do not leave the heated
throw in contact with the
skin for excessive periods of
time. For continuous use, it is
recommended that the LOW
Heat Setting should be used.
Loading ...
Loading ...