Loading ...
Loading ...
Loading ...
5
ENGLISH
To Replace Filter
Dust Bag
WARNING: Unplug cord from
electrical outlet before servicing.
All paper dust bags are not the same. Your ORECK
disposable dust bags have been designed to be used with the
ORECK cleaner and using bags other than genuine ORECK
disposable bags will affect the cleaning ability of your
cleaner and could cause damage to it.
The Belt
The belt on your vacuum cleaner controls the speed of the
revolving brush and is very important for the effective
operation of the cleaner. If the belt becomes stretched or cut,
it will cause the revolving brush to stop completely or slow
down. See instr
uctions in the manual for replacing belt.
An extra belt is stored in the base plate of your cleaner.
When buying replacement belts, use ONLY ORECK genuine
belts. Belts other than ORECK belts will not operate the
revolving brush correctly and may create undue stress which
will cause damage to the motor and brush bearings. Using
belts other than ORECK belts will void the warranty.
Lubrication
The vacuum cleaner motor bearings are factory lubricated
and seated. Further lubrication is not required.
General Cleaner Care
At least once a month, check for and remove excessive
lint, string or hair from revolving brush.
Wipe the outside of the cleaner with a damp cloth. Also
clean the connector deflector assembly area, base of
cleaner and fan housing area. If there is dust in the outer
bag, vacuum it or shake it out.
A little preventative maintenance will keep your cleaner
looking new and will ensure continued cleaning effectiveness.
CAUTION—Wood Floors, Soft (Vinyl, Asphalt Tile,
etc.) Floor Surfaces and Polished Floor Finishes
Use floor and floor finish manufacturer’s recommended
methods of cleaning. The metal strip on the base of the
cleaner could be damaged if used on concrete or abrasive
surfaces, and, therefore, cause damage to wood floors, soft
(vinyl, asphalt tile, etc.) floor surfaces and polished floor
finishes. The roller brush may also scuff very soft finishes. Do
not operate the unit while in the upright and locked position.
Do not let the unit run while in any one stationary position for
any period of time. Keep the unit moving while in operation.
BAG REMOVAL :
1. Unsnap bag door from base.
2. Gently pull bag from
cardboard collar upwards.
BAG INSTALLATION :
1. Slide the cardboard collar
completely onto bag dock
door.
2.
Fir
mly push bag dock door
with both thumbs on
indication point until
it snaps.
Loading ...
Loading ...
Loading ...