Loading ...
Loading ...
Loading ...
22
English
Switch to Eco Power standby
mode
1 Press ECO POWER/STANDBY-ONB to
switch the unit to Eco Power Standby mode.
➜ The backlight on the display panel turns off.
➜ The blue Eco Power indicator turns on.
Note:
– In the Eco Power mode, you can press CLOCK
to switch to the standby mode and view the clock
(if set).
– If the system remains in the standby mode for
more than 90 seconds, it switches to the Eco
Power mode automatically.
Volume control
Tur n VOLUME (-/+) clockwise or anticlockwise
(or press VOL +/- on the remote) to increase
or decrease the volume level.
➜ ”VOL XX” is displayed on the display panel.
“XX” denotes the volume level.
To switch off the volume temporarily
● Press MUTE on the remote.
➜ Playback will continue without sound and
“MUTING” flashes.
● To activate sound reproduction, you can:
– press MUTE again;
– adjust the volume controls;
– change source.
Sound control
DBB, DSC and LOUDNESS sound features
cannot be activated at the same time.
DBB (Dynamic Bass Boost)
DBB enhances the bass response.
● Press DBB on the remote control to enable/
disable DBB feature.
➜ Some discs might be recorded in high
modulation, which causes a distortion at high
volume. If this occurs, switch off DBB or reduce
the volume.
DSC (Digital Sound Control)
DSC provides a different type of preset sound
equalizer setting.
● Press DSC on the remote control repeatedly to
select: FLAT, POPS, JAZZ, CLASSIC or ROCK.
LOUDNESS
LOUDNESS feature enables the system to
automatically increase the treble and bass sound
effect at low volume (the higher the volume, the
lower the treble and bass increase).
● Press LOUDNESS on the remote to enable
or disable LOUDNESS feature.
➜ icon appears/disappears after this feature
is enabled/disabled.
Dimming the display screen
● Press DIM repeatedly to select different levels
of brightness for the display screen.
Demonstration mode
The system has a demonstration mode that
shows the various features offered by the
system.
To activate the demonstration
● In standby mode, press PRESET-/9 on the
system to activate the demo mode.
➜ Demonstration will begin.
To deactivate the demonstration
● Press PRESET-/9 on the system again.
➜ “DEMO OFF” is displayed.
Note:
– Even if you remove the AC power cord and
reconnect it to the wall socket, the demonstration
will remain off until you activate it again.
Basic Functions
pg 001-042_MCD716_12_Eng 2010.6.23, 17:1122
Loading ...
Loading ...
Loading ...