Loading ...
Loading ...
Loading ...
QUICK START GUIDE
u-line.com
8
General Installation
LEVELING INFORMATION
1. Use a level to
level. Level should
be placed along top
edge and side edge
as shown.
2. If the unit is not
level, adjust the legs
on the corners of the unit as necessary.
3.
repeat the previous steps as needed.
INSTALLATION TIP
opening, adjust the rear legs to achieve a total unit rear
height of
Shorten the unit height in the front by adjusting the front
legs. This allows the unit to be gently tipped into the
opening. Readjust the front legs to level the unit after it is
correctly positioned in the opening.
INSTALLATION
1. Plug in the power/electrical cord.
2. Gently push the unit into position. Be careful not
to entangle the cord or water and drain lines, if
applicable.
3. Re-check the leveling, from front to back and side to
surface should be approximately ” (3 mm) below
the countertop.
4. Install the anti-tip bracket.
5. Remove interior packing material and wipe out the
inside of the unit with a clean, water-dampened cloth.
Anti-Tip Bracket
1. Slide unit out so screws on top of unit are easily ac-
cessible.
2. Remove the two screws from the opposite side of the
hinge assembly using a T-25 Torx driver (see below).
3. Place bracket over holes and attach to unit with two
screws removed in step 2 using a T-25 Torx driver.
Tighten screws fully.
4. Gently push unit into position. Be careful not to entan-
gle the electrical cord or water line, if applicable.
5. Check to be sure the unit is level from front to back
and side to side. Make any necessary adjustments.
(3 mm) below the countertop.
6. Secure bracket into adjoining surface.
1
Turn to Adjust
Loading ...
Loading ...
Loading ...